Wattsaving US10 Product Quick Manual

Charging Operation
1 Plug-and-Charge Mode (Default)
When the charging station is on standby, plug in the
connector to your EV, and the LED will turn blue from purple.
The LED will be flashing green while charging.
When your EV is fully charged, the LED will be solid green,
unplug the connector and place it back into the holder.
If you need an emergency stop while charging, please
press the RESET BUTTON then unplug
2 RFID Mode
2.1 How to the Enable the RFID Tags
When the charging station is on standby, press the RESET
button and hold till the LED turns orange from purple.
Place the RFID tag into the RFID Reader (Interrogator) within
15 seconds and wait till the LED turns back to purple.
NOTE
1. Another RFID tag will automatically be enabled without any
operation.
2. Once you enable the RFID mode, the plug-and-charge mode
will be disabled, if you want to switch to the plug-and-charge
mode, please repeat the same operation as activating the RFID
mode.
2.2 RFID Charging Mode
When the charging station is on standby, plug in the connector
to your EV, and the LED will turn blue from purple.
Tap the RFID tag on the RFID Reader.
The LED will be flashing green while charging.
Tap the RFID tag on the RFID Reader again to stop charging.
When your EV is fully charged, the LED will be solid green,
unplug the connector and place it back into the holder.
the connector.