Helpful Hints - Sanyo CE42LM4N-NA - CE - 42" LCD Flat Panel Display Instruction Manual

SPECIFICA
SPECIFICA
Specification
Common specification
Power source 100~240V 60Hz
AV terminal
AV1: CENELEC Standard (Peritel)
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: BNC
Input: RGB, H and V / Y, Pb, Pr and audio L/R
Output: RGB, H and V / Y, Pb, Pr
AV3: BNC
Input: Composite video
Output : Composite video
Audio M.Out: CINCH L/R
HDMI Input :
PC Input
Serial port: RS232C: INput/Output
Net Organiser: POA-LN01 (optional)
When ordering these products, give the Name and Type No. to the
sales dealer
CE42LM4N-NA
Contrast Ratio 800:1
Screen(inches/ cm) 42" / 107 cm
(viewing measured
diagonally)
Display Resolution 1366 X 768 (WXGA)
Viewing angles H:178°, V:178°
Dimensions (WxHxD inch) 41.34" x 25.74" x 5.97"
(WxHxDmm) 1050mm x 654mm x 150mm
Weight 79.4lbs/36Kg
This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc.
It is designed and manufactured to meet rigid U.L. safety standards against risk of fire,
casualty and electrical hazards.
10
TIONS / HELPFUL
TIONS / HELPFUL
HDMI GROUP Standard
HINTS / HOTEL
HINTS / HOTEL

Helpful hints

NO PICTURE
Check if the monitor is plugged in.
Try a different channel, if OK, probably station trouble.
POOR PICTURE
Adjust BRIGHTNESS control.
NO COLOR, PICTURE OK
Adjust COLOR control.
Is the programme in color?
The following faults are not caused by the receiver:
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition
systems, etc. This should normally be a temporary condition, but
should this interference persist, contact your dealer.
Specification
This LCD monitor set allows you to set up the following:
Prohibition of presetting.
This prohibits the use of tuning.
Programme position at Start up
SETTING PROCEDURE:
1 . Press and hold the green button on the Remote control
handset for 5 secongs.
2. Use the 5 or 6 button to highlight Hotel Mode, use the 1
to switch ON or OFF.
Hotel
Hotel mode ON / OFF
On program
AV1-AV3 /RGB/ HDMI/ PC
Preset ON / OFF
Address 007
Baud Rate 19200
: Select
3. Select ON program using the 6 button, select the start up posi-
tion using the 1 or 2 buttons.
(Off / 1-99/ AV1 / RGB/ AV2/ AV3/ HDMI/ PC)
4. Press the MENU button to exit from the menu.
MODE
MODE
: Adjust
: Exit
MENU