Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Draper PT2500-B
Summary of Contents for Draper PT2500-B
- Page 1 Original Instructions Version 2 - 10/24 HAND PALLET TRUCK 85655...
-
Page 2: Product Introduction
Always use the latest version of the manual. Please visit drapertools.com/manuals for the Any other application beyond the conditions established latest version. for use will be considered misuse. Draper Tools accepts no responsibility for improper use of this product. 2.2 Specification Stock No. - Page 3 3. Health and Safety Information • The service life of the hydraulic fluid is approximately • Lower the forks to the lowest height position when the 2 years and the equipment 2-5 years. During truck is not to be used. decommissioning of the equipment certain hazards • Manual pallet trucks are for general operation on should be understood and avoided.
- Page 4 Please examine it for any signs of damage that may have contact the Draper Helpline; contact details can be occurred during shipment. If any part is damaged or found at the back of this manual.
-
Page 5: Pallet Truck Operation
5. Setting Up the Pallet Truck If required, adjust the lever following the steps below: c. If the forks do not descend when the control lever is in the Lower position, turn the adjusting nut a. If the forks elevate while pumping in the Neutral clockwise until raising the control lever lowers position, turn the adjusting nut on the adjusting the forks. - Page 6 7. Maintenance and Troubleshooting 7.4 Reattaching the Handle to the Pistons Axle with hole Offer the handle up to the Whilst holding the handle in Adjust the control lever to the pistonʼs pre-drilled holes. place slide the axle pin lower position. Then feed the through the handle.
-
Page 7: Disposal And Warranty
Air in the hydraulic oil. Purge the air from the oil. Refer to section 7.3. Forks cannot be lowered. The piston rod or pump Contact Draper Tools for advice. body is deformed resulting from partial loading, slanting to one side or overloading. -
Page 8: Contact Details
Product Helpline: +44 (0) 23 8049 4344 Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...
Need help?
Do you have a question about the PT2500-B and is the answer not in the manual?
Questions and answers