Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kyocera AJP-2010
Summary of Contents for Kyocera AJP-2010
- Page 1 AJP-2010 69800959-00 STD 09-21...
- Page 3 凸...
- Page 4 凸 5 or 6 5 or 6 凹 90°...
- Page 6 loosen loosen tighten tighten loosen tighten...
- Page 7 tighten...
- Page 8 Preparation Carefully read and understand these instructions before operating this high pressure washer. Before starting up your machine, we advise you to carefully read through this instruction manual. Follow all instructions Package Contents (Fig.1) to minimize the risk of injuries when using the machine. 1.
-
Page 9: Safety Devices
• Warning! Do not use the device when other persons or • This machine must not be used at temperatures below animals are in the near vicinity unless they are wearing 0℃ . appropriate protective clothing. • The electric supply connection (for example, connec- •... - Page 10 Using the Spray gun (Fig.16) 4. Attach the water supply hose to the faucet (Fig.5) WARNING! Remove dirt and debris from the faucet Pulling the spray gun trigger (21) releases a highly and from the outside and inside of the hose. pressurized water flow.
-
Page 11: Operating The Unit
After Use (Dilution) Cleaning agent in the detergent bottle mixes with water 1. Turn the main switch to the OFF position. and is sprayed diluted to 25%. 2. Turn the water faucet off. 3. Depress the spray gun trigger until all water has Adjusting the Amount of Cleaning Agent stopped flowing from the nozzle. -
Page 12: Maintenance And Storage
Maintenance and storage Note: • Tighten Self-priming filter straight onto the water inlet WARNING! Always disconnect the plug form the socket by turning it in a clockwise direction(If the filter is not prior to maintenance or cleaning. tighten correctly onto the inlet, leaking may occur). To ensure a long and problem free working life, please take •... -
Page 13: Cleaning Of Machine Vents
Cleaning of machine vents The machine should be kept clean so as to let cooling air pass freely through air vents. Storing the Unit • The hoses, nozzles, and spray gun may be stored on the main unit as shown in Figure 41. Storage Pump, hose and accessories should always be emptied of water prior to storing as follows:... -
Page 14: Troubleshooting
Troubleshooting Fault Cause Remedy The plug is damaged. Check the plug and fuses to see if The machine does not run when the There is insufficient voltage. they are okay. ON/OFF switch and spray gun lever The pump is locked. Manually turn over the motor. - Page 15 NOTE...
Need help?
Do you have a question about the AJP-2010 and is the answer not in the manual?
Questions and answers