Advertisement
Advertisement
Table of Contents
Related Manuals for Kyocera AJP-55
Summary of Contents for Kyocera AJP-55
- Page 1 AJP-55 69800928-00 STD 09-21...
- Page 3 （OFF） （ON）...
- Page 4 loosen loosen tighten tighten loosen tighten tighten...
- Page 5 Especially check: Carefully read and understand these instructions before operating this high pressure washer. The insulation of the electric cable should be faultless and without any cracks. If the electric cable is damaged, it should be replaced by our authorized distributor. Package Contents 1.
-
Page 6: Safety Devices
• This appliance is not intended for use by persons (in- Motor pump protection cluding children) with reduced physical, sensory or men- The motor is equipped with a motor circuit breaker switch. tal capabilities, or lack of experience and knowledge, When the motor starts to run hot, it is cut out automatically unless they have been given supervision or instruction by this switch. - Page 7 How to use Starting up 1. Open the water inlet. Press the safety lock button (13) WARNI NG! M ake sure to clean t he Self- pr iming on the spray gun and pull back the trigger lever in or- filter, the strainer on Self-priming hose, and filter der to bleed the trapped air out of the device.
-
Page 8: Maintenance And Storage
If the above-problem occurs, remove Self-priming filter and • When installing the filter cap, make sure that the filter then set it again in the following procedure: is properly set in the filter case and close the filter cap 1. Confirm that the filter inside of while holding the case vertically. -
Page 9: Troubleshooting
Troubleshooting Fault Cause Remedy The machine does not run when the The plug is damaged. Check the plug and fuses to see if ON/OFF switch and spray gun lever There is insufficient voltage. they are okay. are pressed. The pump is locked. Manually turn over the motor. - Page 10 NOTE...
- Page 11 NOTE...
Need help?
Do you have a question about the AJP-55 and is the answer not in the manual?
Questions and answers