BOULT Q Manual

Know your headphones

What's in the box

Headphones
Type-C Charging Cable
3.5mm Audio Cable
Manual
Warranty Card

Product specification

Bluetooth Name - Boult Audio Q
Bluetooth Range - ~10m/33ft (without any obstacles)
Headphones Charging Time – 120 mins
Frequency Range - 20Hz - 20KHz
Technology - HFP/HSP/A2DP/AVRCP
Input - DC5V = 1A
Connector – 3.5mm

Operating Instructions

Power ON/OFF:
Power ON: Long press the Multifunction (MFB) button for 2 seconds, the LED indicator will turn blue, and the headphones will enter the Bluetooth pairing mode.
Power OFF: A Long press the Multifunction (MFB) button for 5 seconds, the LED indicator will turn red and then turn OFF

Pairing:
When the headphone is turned on, the headphone enters the Bluetooth pairing mode automatically, and the RED and BLUE lights flash alternately
Activate Bluetooth on the device, turn on Bluetooth, search for pairing name "Boult Audio Q" and click on it. On successful connection, the blue light turns ON

3.5mm AUX Mode:
Plug the 3.5mm audio cable into the aux port to listen in wired mode. Please note that the headphones' buttons and microphone cannot be used once the cable is connected.

Charge:
Connect one end of the charging cable to the headphone interface (Type-C) and the other end to any USB charger or charging device. While charging the LED stays red and once the headphones are fully charged the LED turns blue.
Note: While charging, the headphones must not be powered on or used. Also, when the battery is low, it gets indicated by red LED flashes.

How to use your Headphones

Play/Pause
Press the MFB once

+
Volume Up: Press the "+" button
Next Track: Long press the "+" button for 1 sec

-
Volume Down: Press the "-" button
Previous Track: Long press the "-" button for 1 sec

Answer the Call
Press the MFB once

Reject Call
Long press the MFB for 2 sec

End Call
Press the MFB once

EQ mode/Game mode:
EQ Mode: Press the EQ mode key to choose between Pop, Bass, Rock and Vocal mode
Game mode: Long Press EQ button to enable/disable gaming mode

Reset
Press and hold the "+" and "-" buttons for 5 seconds at the same time, the headphones will separate the Bluetooth connection and restore factory settings.

Maintenance Instructions

1. Do not dismantle the product in any way, as this can result in a fire or electrical breakdown, causing the product to be completely damaged. As this is extremely dangerous, we request that any maintenance or servicing of the headphones be performed only by a qualified service provider/manufacturer
2. Please do not remove the battery by yourself; this is a task that should be handled by a service provider/ manufacturer. Replacing the current battery with an ill-fitting set can cause a fire or electric hazard, so it is strongly discouraged.