Table of Contents
Advertisement
4. Secure the Hard Drive:
Secure the Western Digital hard drive in an available 3.5-inch drive bay (typically
adjacent to the floppy disk drive) using the four mounting screws provided.
Note: For proper grounding, be sure to use all four screws.
Power on Your Computer
1. Replace and secure the system cover, reconnect the power cord, and power on the system.
This concludes the hard drive installation process.
2. At startup, your system BIOS should auto-detect the hard drive with a series of system
messages identifying the Western Digital hard drive. If there is no hard drive detection or
an error message appears, you will have to enter the system BIOS to set up the hard drive.
If the drive was detected, you may now format and partition the drive.
a) To configure the system BIOS, proceed to the next section on page 8.
b) To format and partition the drive, skip to "Data Lifeguard Tools v11.0" on page 9.
WESTERN DIGITAL EIDE HARD DRIVE
Mounting frame
INSTALLATION GUIDE
INSTALL THE HARD DRIVE - 7
Hide quick links:
Advertisement
Table of Contents
