Connecting The Units - Pioneer DVHP5000MP - Car DVD Receiver Installation Manual

Connecting the Units

Power cable connection
IP-BUS input (Blue)
Optical input
This product
Rear audio output
(Refer to Fig. 4 and Fig. 6.)
Antenna jack
Multi-CD player
IP-BUS cable
(sold separately)
Refer to Fig. 3 – Fig. 6.
Yellow/black
If you use a cellular telephone, connect it via the
Audio Mute lead on the cellular telephone. If not,
keep the Audio Mute lead free of any
connections.
Yellow
Fuse holder
To terminal always supplied
with power regardless of
ignition switch position.
Orange/white
Fuse resistor
To lighting switch terminal.
Red
Fuse resistor
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Black (ground)
To vehicle (metal) body.
Connecting the Units
Connection method
1. Clamp the lead. 2. Clamp firmly with
needle-nosed
pliers.
Note
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the
parking brake switch.
Power supply side Parking brake
switch
Ground side
Blue/white
To system control terminal of the power amp
or Auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Gray
White
+ +
Front speaker Front speaker
≠ ≠
Gray/black
White/black
Left Right
Green Violet
+ +
Rear speaker
Rear speaker
≠ ≠
Green/black Violet/black
With a 2 speaker system, do not connect anything
to the speaker leads that are not connected to speakers.
When you connect separately sold multi-channel processor
(DEQ-P7000) to this unit, do not connect anything to the
speaker leads and system remote control (blue/white).
Connecting the Units
Connecting to separately sold power amp
15 cm (5-7/8 in.)
Front output
(FRONT OUTPUT)
15 cm (5-7/8 in.)
Subwoofer output
or non fading output
(SUBWOOFER OUTPUT or
NON-FADING OUTPUT)
Rear audio output
(Refer to Fig. 4 and Fig. 6.)
Optical input
This product
Antenna jack
(Refer to Fig. 2.)
System remote control
IP-BUS input (Blue)
(Refer to Fig. 2.)
When you connect separately sold multi-channel
processor (DEQ-P7000) to this unit, do not connect
anything to the speaker leads and system remote
control (blue/white).
Note
When you connect DEQ-P7000 to this unit, separately
sold power amp must be connected to DEQ-P7000.
Note
Change the initial setting of this product (refer to the
Operation Manual). The subwoofer output of this unit
is monaural.
Fig. 2
Connecting the Units
Power amp
(sold separately)
Connecting cords
with RCA pin plugs
(sold separately)
Power amp
(sold separately)
Use this for connections when
you have the separately available
amplifier.
Blue/white
To system control terminal of the
power amp or Auto-antenna relay
control terminal
(max. 300 mA 12 V DC).
System remote control
Subwoofer
Subwoofer
+ +
≠ ≠
Left Right
Front speaker Front speaker
+ +
≠ ≠
Fig. 3