Pioneer DEH-P7900BT Installation Manual page 3

Connecting the Units
7 When not connecting a rear speaker lead to a Subwoofer
Subwoofer output
(SUBWOOFER OUTPUT)
Front output
Rear output
(FRONT OUTPUT)
(REAR OUTPUT)
This product
15 cm (5-7/8 in.)
Antenna jack
iPod with Dock
Dock connector port
Connector
Gray
Dock connector
2 m (6 ft. 7 in.)
Interface cable
(e.g., CD-I200)
Wired remote input
(sold separately)
Hard-wired remote control adaptor can
be connected (sold separately).
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio
Mute lead on that equipment. If not, keep the Audio Mute lead free of any Blue/white
connections. Connect to system control terminal of the power
Fuse (10 A)
amp or auto-antenna relay control terminal (max.
300 mA 12 V DC).
Yellow
Connect to the constant 12 V supply terminal.
Fuse resistor
Red
Connect to terminal controlled by ignition switch (12 V DC).
Fuse resistor
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
With a 2 speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
Perform these connections when
using the optional amplifier.
23 cm (9 in.)
15 cm (5-7/8 in.)
15 cm (5-7/8 in.)
Microphone input
14 cm (5-1/2 in.)
18 cm (7-1/8 in)
IP-BUS input
(Blue)
AUX jack (3.5 ø) 4 m (13 ft. 1 in.)
Connect with RCA cables
(sold separately)
Use a stereo mini plug cable
to connect with auxiliary
equipment.
Microphone
Multi-CD player
IP-BUS cable (sold separately)
System remote control
+ +
Front speaker Front speaker
≠ ≠
White Gray
+ +
Front speaker Front speaker
≠ ≠
White/black Gray/black
Left
Green Violet
+ +
Rear speaker Rear speaker
≠ ≠
Green/black Violet/black
+ +
Rear speaker Rear speaker
≠ ≠
+ +
Subwoofer Subwoofer
≠ ≠
7 When using a Subwoofer without using the optional amplifier
Power amp
(sold separately)
Power amp
(sold separately)
Power amp
(sold separately)
iPod with Dock
Connector
Dock connector
Interface cable
(e.g., CD-I200)
(sold separately)
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio
Mute lead on that equipment. If not, keep the Audio Mute lead free of any
connections.
Yellow
Connect to the constant 12 V supply terminal.
Red
Connect to terminal controlled by ignition switch (12 V DC).
Orange/white
Connect to lighting switch terminal.
Right
Black (chassis ground)
Connect to a clean, paint-free metal location.
Note:
Change the initial setting of this unit (refer to the Operation
Manual). The subwoofer output of this unit is monaural.
23 cm (9 in.)
Subwoofer output
15 cm (5-7/8 in.)
(SUBWOOFER OUTPUT)
15 cm (5-7/8 in.)
Front output
Subwoofer output
(FRONT OUTPUT)
Microphone input
(REAR OUTPUT)
14 cm (5-1/2 in.)
This product
18 cm (7-1/8 in)
15 cm (5-7/8 in.)
Antenna jack
IP-BUS input
(Blue)
AUX jack (3.5 ø)
Dock connector port
Use a stereo mini plug cable
to connect with auxiliary
Gray
equipment.
2 m (6 ft. 7 in.)
Multi-CD player
Wired remote input
IP-BUS cable (sold separately)
Hard-wired remote control adaptor can
be connected (sold separately).
Blue/white
Connect to system control terminal of the power
Fuse (10 A) amp or auto-antenna relay control terminal (max.
300 mA 12 V DC).
Fuse resistor
Front speaker
Left
Fuse resistor
Subwoofer (4 Ω)
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do
not connect anything with Green and Green/black leads.
ENGLISH
4 m (13 ft. 1 in.)
Microphone
White Gray
+ +
Front speaker
≠ ≠
White/black Gray/black
Right
Green Violet
+ +
Subwoofer (4 Ω)
≠ ≠
Green/black Violet/black
+
Green Violet
Subwoofer
Not used.
(4 Ω) × 2
≠
Green/black Violet/black