Whelen Engineering Company TIONWEG Installation Manual

51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For
more information, visit www.whelen.com/regulatory.
The wedge is designed for the customer that wants to
mount their ION™ T Series™ lighthead to sit on an angle.
You can use the wedged spacers individually at 5 or 15
degrees. You can also use the wedges in any combination
to achieve the desired angle.
Fig. 1
#6 x 1-1/4
Phillips Pan
Head Sheet
Metal Screw
©2021 Whelen Engineering Company Inc.
Form No.14D97 (040721)
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For
more information, visit www.whelen.com/regulatory.
The wedge is designed for the customer that wants to
mount their ION™ T Series™ lighthead to sit on an angle.
You can use the wedged spacers individually at 5 or 15
degrees. You can also use the wedges in any combination
to achieve the desired angle.
Fig. 1
#6 x 1-1/4
Phillips Pan
Head Sheet
Metal Screw
©2021 Whelen Engineering Company Inc.
Form No.14D97 (040721)
NOTE: always place
the larger wedge on
the bottom against the
mounting surface.
1. To mount a lighthead
2. Mount the lighthead
Wedge
ION T-series™
Mounting Flange
For warranty information regarding this product, visit www.whelen.com/warranty
NOTE: always place
the larger wedge on
the bottom against the
mounting surface.
1. To mount a lighthead
2. Mount the lighthead
Wedge
ION T-series™
Mounting Flange
Page 1
For warranty information regarding this product, visit www.whelen.com/warranty
Wedge Spacer for ION-T Series™ Lightheads
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Customer Service e-mail: custserv@whelen.com
Fig. 2
using a single wedge,
fold the tabs back on
the wedge (toward the
side that sits on the
vehicle / Fig. 2) and
mount to vehicle as
shown (Fig. 1).
using the supplied #6
x 1-1/4 Phillips Pan
Head Sheet Metal
Screws.
Wedge Spacer for ION-T Series™ Lightheads
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Customer Service e-mail: custserv@whelen.com
Fig. 2
using a single wedge,
fold the tabs back on
the wedge (toward the
side that sits on the
vehicle / Fig. 2) and
mount to vehicle as
shown (Fig. 1).
using the supplied #6
x 1-1/4 Phillips Pan
Head Sheet Metal
Screws.
Installation Guide:
Model: TIONWEG
Wedge that sits
on Vehicle
FRONT VIEW OF WEDGE
fold tab in
towards rear
of wedge
REAR VIEW OF WEDGE
fold tab down
to sit flush
against rear
of wedge
Installation Guide:
Model: TIONWEG
Wedge that sits
on Vehicle
FRONT VIEW OF WEDGE
fold tab in
towards rear
of wedge
REAR VIEW OF WEDGE
fold tab down
to sit flush
against rear
of wedge