Whelen Engineering Company TIR3 Super-LED/M4 Installation Manual

ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
FIG. 1
Installation:
1. Loosen (do not remove) the upper trunk hinge bolt on one side of the
vehicle enough to slide the bracket into place as shown.
2. Slide the bracket under the bolt and tighten the bolt firmly.
3. Ty-wrap the wires to the trunk hinge as you extend them to your power
source, being very careful that the wires won't be pinched when you
open and close the trunk.
4. Repeat this procedure for the other side of the vehicle. Refer to the
instructions included with your lighthead for wiring information.
©2004 Whelen Engineering Company Inc.
Form No.13955B (022410)
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
FIG. 1
Installation:
1. Loosen (do not remove) the upper trunk hinge bolt on one side of the
vehicle enough to slide the bracket into place as shown.
2. Slide the bracket under the bolt and tighten the bolt firmly.
3. Ty-wrap the wires to the trunk hinge as you extend them to your power
source, being very careful that the wires won't be pinched when you
open and close the trunk.
4. Repeat this procedure for the other side of the vehicle. Refer to the
instructions included with your lighthead for wiring information.
©2004 Whelen Engineering Company Inc.
Form No.13955B (022410)
®
™
TIR3 Super-LED®/M4 Lighthead Mounting Bracket
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
For warranty information regarding this product, visit www.whelen.com/warranty
®
™
TIR3 Super-LED®/M4 Lighthead Mounting Bracket
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
Page 1
For warranty information regarding this product, visit www.whelen.com/warranty
Installation Guide:
Trunk Mount - Ford Crown Victoria
This bracket will mount to the inside of the trunk
using one of the two bolts that hold the trunk
hinges on.
WARNING: Install the brackets on one side of
the vehicle at a time. If you loosen both trunk
hinge bolts at the same time the trunk will
shift and will not line up properly.
Optional: .156" Diameter hole for
customer supplied sheet metal
screw for extra reinforcement
TRUNK
HINGE BOLTS
(10mm Socket)
TRUNK HINGE
Installation Guide:
Trunk Mount - Ford Crown Victoria
This bracket will mount to the inside of the trunk
using one of the two bolts that hold the trunk
hinges on.
WARNING: Install the brackets on one side of
the vehicle at a time. If you loosen both trunk
hinge bolts at the same time the trunk will
shift and will not line up properly.
Optional: .156" Diameter hole for
customer supplied sheet metal
screw for extra reinforcement
TRUNK
HINGE BOLTS
(10mm Socket)
TRUNK HINGE
K
T R U N
FIG. 2
K
T R U N
FIG. 2