Talius MO-2125 Instructions

MO-2125,MO-2150
Instruction
A-00
Features
Built-in Receiver Switch Direction
Jog & Tilt Stall Protection
Fields Of Application
The motor is suitable for motorization of roller blinds.
Specifications
Working Temperature: -10℃ ~ +70℃ Radio Frequency:
Rated Voltage: AC 120V,60Hz; AC 230V,50Hz; AC 220V,60Hz Thermal Protection Time: > 4 minutes
* For more motor models and specific torque, please refer to the nameplate.
Attention
Never drop, knock, drill or submerge the motor. Keep the power cable in right position as following.
Important safety instructions to be read before installation.
Incorrect installation can lead to serious injury and will void manufacturer's liability and warranty.
Wiring
Three wires: AC 230V,50Hz; AC120V,60Hz; AC220V,60Hz
/
230V,50Hz
120V,60Hz
220V,60Hz
1 Neutral line = Blue / White
2 Live line = Brown / Black
3 Earth line = Green Yellow / Green
-1-
Motor Installation
Step 1 Cut drive tube to required length.
Drive Adapter
Circlip
Radio Lock Step 3 Mount correct crown & drive adapter on
the motor. Make sure drive adapter fits firmly and
Wind-sun-rain Sensor
crown rotates freely.
Compatible
Caution
1. Do not expose motor to humid or extreme temperature conditions.
2. Do not drill into motor.
3. Do not cut the antenna and keep it clear from metal objects.
4. Do not allow children to play with this device.
5. If power cable or connector is damaged, do not use.
6. Ensure correct crown and drive adaptor are used.
7. Ensure power cable and aerial is clear and protected from moving parts.
8. Cable routed through walls shall be properly isolated.
9. Motor is to be mounted in horizontal position only.
10. Before installation, remove unnecessary cords and disable equipment not needed for powered operation.
11. Installation and programming to be performed by a qualified professional, use or modification outside
433.92MHz
the scope of this instruction may void warranty.
Important Safety Instructions To Be Read Prior To Operation.
Setting Notice
Please read following points of attention carefully before setting.
1. Please use accessories kits to protect the wires which are not used.
2. Operating：
① The valid interval of the emitter button is 10s, the emitter will quit the set after 10s.
② The motor will jog or beep for hint, please do the next step after the hint.
3. If the emitter lost, please setting up again with new emitter.
4. One motor can store maximum 10 channels; after fully stored, if pair new channels, only the last one will
be covered circularly.
Button Instructions
UP
STOP
DOWN
Motor
Drive tube
Drive tube
Step 2 Ensure tube edge is clean and burr-free.
Crown
Bracket
Bracket
Step 4 Align the notches on the crown and drive
adapter with the drive tube, slide and fit the motor
into drive tube. Mount idler and bracket on both
ends.
LCD
Channel +
Channel - P2 P2
-2-