Talius Somfy RTS Quick Start Manual

Programming Limit

Settings for the First Time

If you did not request Talius to pre-set the limit settings on your unit prior to shipping, follow the steps below
to set UPPER and LOWER Limits for the first time. If you requested Talius to pre-set the limits but need to adjust
them, please refer to the instructions on the reverse.


CHECK THE DIRECTION OF OPERATION


Press and hold the DOWN button on the remote and confirm that the motor
moves in the down direction (the motor will operate in momentary fashion). To
change the direction, press and hold the MY (stop) button until the motor jogs.

Operate motor to your desired Upper Limit position.

SET THE LOWER LIMIT

Press and hold the MY (stop) and DOWN buttons on the remote until the motor

moves in the down direction, then release.
Stop the motor where the Lower Limit should be set. Adjust by pressing the UP or
DOWN buttons on the remote.

SET THE UPPER LIMIT

Press and hold the MY (stop) and UP button on the remote to move the motor to

the desired Upper Limit position, then release.
The motor will stop at the original upper point. Adjust if necessary.

CONFIRM THE LIMIT SETTINGS


Press and hold the MY (stop) button until the motor
jogs to confirm the setting.

SAVE THE LIMIT SETTINGS


Press and hold the PROGRAM button on the back of the remote until the motor
jogs. It will now operate in a maintained fashion.
Double check limits as a precaution.
INITIATE PROGRAMMING MODE
On the remote, press both the UP and DOWN buttons
at the same time until the motor jogs.
Note: After every command the motor will jog to confirm.
Talius © 2020
Somfy® RTS Motors