Related Manuals for Beko CM 11141
Summary of Contents for Beko CM 11141
- Page 1 Washing Machine User Manual CM 11141 Document Number: 2820532419_EN/ 18-09-24.(14:28)
-
Page 2: General Safety Instructions
1 General safety instructions • Do not force open the locked loading door. The door will This section includes security open immediately after the instructions which may help prevent washing cycle has ended. If the the injuries and material damage risks. door does not open, apply the All kinds of warranties shall be invalid if solutions provided for “Loading... -
Page 3: Children's Safety
1.3 Children’s safety CAUTION! • Do not forget to close the CAUTION! loading door when leaving the • This product can be used room where the product is by children at and above 8 located. years old and by persons •... -
Page 4: Important Instructions For Environment
This product has been manufactured with high DANGER quality parts and materials which can be reused and are suitable for recycling. Do not dispose • Do not wash the product by of the waste product with normal domestic spraying or pouring water onto and other wastes at the end of its service life. -
Page 5: Technical Specifications
4 Technical specifications Supplier name or trademark Beko CM 11141 Model name 7164171400 Rated capacity (kg) Maximum spin speed (rpm) 1400 Built-in Height (cm) Width (cm) Depth (cm) Single Water inlet / Double Water inlet • / - • Available... -
Page 6: Appropriate Installation Location
4.1 Installation • Leaving a gap at the sides of the machine is suggested to reduce vibration and noise INFORMATION • On a graduated floor, do not place the product next to the edge or on a platform. • Your washing machine automatically •... -
Page 7: Connecting Water Supply
4.1.4 Connecting water supply CAUTION! INFORMATION • Your drain house will be flooded if the • It is necessary to have 10 – 80 liters of hose comes out of its housing during water flowing from the fully open tap in water discharge. -
Page 8: Adjusting The Feet
4.1.6 Adjusting the feet qualified electrician install a 16 Amp fuse. • The voltage specified in the "Technical CAUTION! specifications" section must be equal to your mains voltage. • In order to ensure that the product operates more silently and vibration-free, it must •... - Page 9 4.2 Preparation 4.2.3 Tips for energy and water saving Following information will help you use the 4.2.1 Sorting the laundry product in an ecological and energy/water- • Sort laundry according to type of fabric, efficient manner. colour, and degree of soiling and allowable •...
-
Page 10: Using Detergent And Softener
4.2.6 Using detergent and softener • Wash woollens at suggested programme with special detergent made specifically for INFORMATION woollens. • Please review the programme descriptions part • When using detergent, softener, starch, for suggested programme for different textiles. fabric dye, bleach and descaling agents; •... - Page 11 If the product is equipped with a liquid Using limescale remover detergent part: • When required, use limescale removers manufactured specifically for washing machines only. Using bleaches • Select a programme with prewash and add the bleach at the beginning of the prewash. Do not put detergent in the prewash compartment.
-
Page 12: Tips For Efficient Washing
4.2.7 Tips for efficient washing Clothes Light Colours and Black/Dark Delicates/ Colours Whites Colours Woollens/Silks (Recommended (Recommended (Recommended temperature (Recommended temperature temperature range temperature range range based on soiling level: range based on soiling level: based on soiling based on soiling 40-90 oC) cold-40 oC) level: cold -40 oC) -
Page 13: Operating The Product
4.3 Operating the product 1 - Programme Selection Knob (Uppermost position On / Off) 4.3.1 Control panel 2 - Display 3 - End Time Adjustment Button 4 - Programme Follow-up Indicator 5 - Start/Pause Button 6 - Auxiliary Function Button 3 7 - Auxiliary Function Button 2 8 - Auxiliary Function Button 1 9 - Spin Speed Adjustment Button... - Page 14 • : Selectable * : Automatically selected, cannot be cancelled. ***: Eco 40-60 with 40 °C temperature selection is the test programme in accordance with EN 60456:2016/A11:2020 and energy label with Commission Delegated Regulation (EU) 2019/2014 - : See the programme description for maximum load. INFORMATION •...
-
Page 15: Main Programmes
4.3.5 Main programmes Hijyen+ • Depending on the type of fabric, use the Applying a steam step at the beginning of the following main programmes. programme allows to soften the dirt easily. • Pamuklu Use this programme for your laundry (baby clothes, bed sheets, bedlinen, underwear, etc. -
Page 16: Special Programmes
• Apply the pre-treatment chemical on your auto stain programme, you can remove 24 types garments directly or add it together with of stains grouped into two categories according detergent when the machine starts to take water to quick function selection. Here you can see the from the main washing compartment. - Page 17 4.3.10 Auxiliary function selection INFORMATION Select the desired auxiliary functions before starting the programme. You can also select • Use a lower spin speed for delicate laundries. or cancel auxiliary functions suitable for the 4.3.8 Temperature selection running programme without pressing the Start/ Pause button while the machine is operating.
-
Page 18: Functions/Programmes Selected By Pressing The Function Buttons For 3 Seconds
INFORMATION INFORMATION • When you select this function, the • If the Programme Selection knob is turned maximum amount of laundry to when the Child Lock is enabled, "Con" be loaded into the machine must appears on the display. While the Child Lock be half the maximum amount is enabled, you cannot make any change in given in the programme table. - Page 19 Cancelling the delayed end function knob, the programme follow-up light will remain on or go off depending on the selected programme. If you want to cancel the delayed end time If you do not cancel the function by pressing the countdown and start the programme immediately: Auxiliary Function button 3 for 3 seconds, it will be 1.
-
Page 20: Loading Door Lock
INFORMATION • If the machine does not proceed to the spinning step, the Rinse Hold function might be active or the automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the machine. 4.3.14 Loading door lock There is a locking system on the loading door of the machine that prevents opening of the loading... -
Page 21: Cancelling The Programme
Changing the auxiliary function, speed and 4.3.17 End of programme temperature At the end of the programme, “End” will be displayed. Depending on the step the programme has reached, you can cancel or select auxiliary 1. Wait until the light of the loading door goes functions. -
Page 22: Maintenance And Cleaning
4.4 Maintenance and cleaning INFORMATION Service life of product extends and frequently • Foreign metal substances will cause experienced problems will be reduced if it is rust stains in the drum. Clean the cleaned at regular intervals. stains on the drum surface by using 4.4.1 Cleaning the detergent drawer cleaning agents for stainless steel. -
Page 23: Draining Remaining Water And Cleaning The Pump Filter
4.4.5 Draining remaining water 3 Follow the below procedures in order to drain water. and cleaning the pump filter The filter system in your machine prevents solid items such as buttons, coins and fabric The product does not have an emergency fibres clogging the pump impeller during water drain hose, in order to drain the water: discharge of washing water. -
Page 24: Troubleshooting
5 Troubleshooting Loading door cannot be opened. • Loading door lock is activated because of the water level in the product. >>>Drain the water by running the Pump or Programmes do not start after the loading door is Spin programme. closed. - Page 25 Washing performance is poor: Laundry turns gray. (**) Washing machine does not rinse well. • Insufficient amount of detergent has been used over a long • The amount, brand and storage conditions of the detergent period of time. >>>Use the recommended amount of used are inappropriate.
- Page 26 Too much foam forms inside the product. (**) • Improper detergents for the washing machine is used. >>>Use detergents appropriate for the washing machine. • Excessive amount of detergent is used. >>>Use only sufficient amount of detergent. • Detergent was stored under improper conditions. >>>Store detergent in a closed and dry location.
Need help?
Do you have a question about the CM 11141 and is the answer not in the manual?
Questions and answers