HP dx2450 - Microtower PC Hardware Reference Manual page 39

9. Slide the drive in through the front of the chassis (1) until the bezel on the drive is evenly aligned
with the computer front bezel and install the M3 metric retainer screw (2) as shown in the illustration
below.
NOTE:
M3 metric retainer screws for diskette drives or media card readers are black. Refer to
Additional Drives on page 24
Figure 2-25
10. Connect the appropriate drive cables:
a. If installing a diskette drive, connect the power and data cables to the rear of the drive and
connect the other end of the data cable to the connector on the system board labeled FLOPPY.
b. If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled F_USB2.
NOTE:
board drive connectors.
11. Replace the front bezel and access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the access panel was removed.
ENWW
Extra drive retainer screws are provided on the interior of the front bezel if needed. The
for an illustration of the retainer screws location.
Installing a 3.5-inch Device (Media Card Reader Shown)
Refer to System Board Drive Connections on page 26
Installing
for an illustration of the system
Installing Additional Drives 33