Download Print this page
Step2 Vero Poolside Basketball Hoop Owner's Manual
Step2 Vero Poolside Basketball Hoop Owner's Manual

Step2 Vero Poolside Basketball Hoop Owner's Manual

Advertisement

Quick Links

TIP: To prevent scratches, assemble product on top of box or
other soft surface.
CONSEIL: Pour éviter les rayures, assemblez le produit sur le
dessus de la boîte ou sur une autre surface douce.
CONSEJO: Para evitar rayones, monte el producto encima de la
caja u otra superficie blanda.
02/05/2025
Vero Poolside Basketball Hoop
Owner's Manual
Le Manuel du Propriétaire | El Manual del Propietario
PLEASE NOTE: Screws form their own holes. Apply
pressure.
VEUILLEZ NOTER : Les vis forment leurs propres trous.
Appliquer une pression.
POR FAVOR NOTA: Los tornillos forman sus propios
agujeros. Aplicar presion.
2
1
195105A01B
When the temperature is freezing or
below, store indoors.
Lorsque la température descend à
zéro ou en dessous, conservez-la à
l'intérieur.
Cuando la temperatura baje a cero o
menos, guárdela en interiores.
Two people recommended.
Deux personnes recommandées.
Se recomiendan dos personas.
5561

Advertisement

loading
Need help?

Need help?

Do you have a question about the Vero Poolside Basketball Hoop and is the answer not in the manual?

Questions and answers

Summary of Contents for Step2 Vero Poolside Basketball Hoop

  • Page 1 Vero Poolside Basketball Hoop ™ Owner’s Manual Le Manuel du Propriétaire | El Manual del Propietario When the temperature is freezing or TIP: To prevent scratches, assemble product on top of box or below, store indoors. other soft surface. Lorsque la température descend à...
  • Page 2: Installation

    TENGA EN CUENTA LAS SIGUIENTES OBSERVE THE FOLLOWING STATEMENTS AND OBSERVEZ LES ÉNONCÉS ET LES AVERTISSEMENTS DECLARACIONES Y ADVERTENCIAS PARA REDUCIR WARNINGS TO REDUCE THE LIKELIHOOD OF SUIVANTS POUR RÉDUIRE LE RISQUE DE LA POSIBILIDAD DE SUFRIR LESIONES GRAVES O SERIOUS OR FATAL INJURY.
  • Page 3 Ball Specifications/ Caractéristiques des ballon/ Especificaciones de las pelota To inflate: Use a standard bicycle pump with an inflating pin as shown. Locate inflation valve, insert pin and use pump to inflate. Inflate slowly and check ball dimensions frequently. Caution: Do not OVER-INFLATE! Over-inflation can stretch and permanently damage material or cause balls to burst.
  • Page 4 x4 | x8 | 2” (50,8 mm) 3/4” (19.05 mm) 5/16” 5/16” Nylon 47/64” REQUIRED (Not Included) REQUIS (Non inclus) NECESARIO (No incluido)
  • Page 5 • Fill the base (B) using a hose with water until full. Base will hold approximately 18 gal. (68.13 L) and weigh 150 lbs (68.03 kg) when filled. • Remplissez la base (B) avec de l'eau à l'aide d'un tuyau. La base peut contenir environ 18 gal.
  • Page 6 • Peel protective sheet off front and back of backboard before installation. • Retirez la feuille protectrice de l’avant et de l’arrière du panneau arrière avant l’installation. • Retire la lámina protectora de la parte delantera y trasera del tablero antes de la instalación.
  • Page 7 • To install net (C2) onto hoop (C1) , keep placing loops onto the hoop as shown in step 10b. Pull net as you go until net is fully attached as shown in step 10c. • Pour installer le filet (C2) sur le cerceau (C1), continuez à...

This manual is also suitable for:

5561kr