Subscribe to Our Youtube Channel
Related Manuals for Russell Taylors SG-10
Summary of Contents for Russell Taylors SG-10
- Page 1 STEAM GENERATOR USER MANUAL SG-10 This product is backed by a 2-year warranty against manufacturing defects. For warranty claims, please email us at support@russelltaylors.com and provide your order number or invoice.
-
Page 2: Important Safeguards
4. If the power supply cord is damaged, it must be replaced by the Russell Taylors service team, please contact us at support@russelltaylors.com. 5. Do not allow the cord to touch the soleplate when it is hot. - Page 3 damage caused by unauthorized accessories will result in termination of warranty. 12. When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. 13. Never fill the water tank with hot water, scented liquids, vinegar, starch, descaler, fabric softener or other chemical agents.
-
Page 4: Temperature Dial
TEMPERATURE DIAL Linen (170℃<T<230℃) Cotton (140℃<T<210℃) Wool Nylon Silk (100℃<T<160℃) (70℃<T<120℃) -
Page 5: Filling With Water
FILLING WITH WATER Fill the water tank with water through the filling aperture. Make sure the water does not exceed the maximum level listed on the water tank. TEMPERATURE DIAL Turn the temperature dial to set the ironing temperature based on the garment that needs to be ironed. - Page 6 CLEAN BUTTON (WITH INDICATOR) 1. The appliance must be cleaned when the clean indicator lights solidly. Before cleaning, prepare a container for collecting the wastewater. 2. Hold and press the “Clean button” for 2 seconds. When the buzzer sounds, keep away from the appliance to avoid being burnt by high-temperature steam during the cleaning process.
-
Page 7: Shot Of Steam
appliance is on “Steam” mode. Press the “Steam trigger” once if the appliance is not on the “Steam” mode. The appliance will spray water during cleaning if the appliance is performed cleaning under the “Water Spray” mode. The appliance must be performed cleaning under the “Steam”... -
Page 8: Using Your Steam Station
Correct placement Wrong placement Wrong placement Fig.3 BEFORE FIRST USE 1. Remove any sticker or protective foil from the soleplate. 2. Fill the water tank with water and heat up the iron at the maximum temperature, and then iron over a piece of damp cloth for several minutes for the purpose of removing any residue on the soleplate according to the section of “Steam ironing”. - Page 9 correctly (see Fig.3). 3. Connect the plug to wall outlet, and then turn the temperature dial to select your desired temperature setting, which is depended on the fabric of garment. Refer to “IRONING TIPS” and “ADDITIONAL TABLE” as below when select temperature. 4.
-
Page 10: Cleaning And Maintenance
correctly (see Fig.3). 4. Connect the plug to wall outlet, and then turn the temperature dial to select your desired temperature setting, which is depended on the fabric of garment. Refer to “IRONING TIPS” and “ADDITIONAL TABLE” as below when select temperature. -
Page 11: Ironing Tips
a damp cloth or a non-abrasive (liquid) cleaner. NOTE: Do not use chemical, steel, wooden or abrasive cleaners because it will scrape the soleplate. 2. Clean the upper part of iron with a soft damp cloth. Wipe any water droplets on the unit base and the thermal insulation stand with dry cloth. - Page 12 side to avoid being shone. -Velvet and other textures that rapidly become shiny should be ironed in one direction with light pressure applied. Always keeps the iron moving at any moment. -Pure wool fabrics (100% wool) may be ironed with the steam iron.
Need help?
Do you have a question about the SG-10 and is the answer not in the manual?
Questions and answers