Table of Contents
Advertisement
Quick Links
STEAM IRON
www.russelltaylors.co.uk
Safety Instructions:
When using your iron, basic safety precautions should always be followed:
1.
Make sure the power used corresponds with the one indicated on the rating label.
2.
Use the iron only for needed use as descried in the instruction manual.
3.
Close supervision is necessary when any appliance is used near children. Do not
leave iron unattended while connected or on an ironing board. Burns can occur
from touching hot metal parts, hot water or steam.
4.
Keep the iron out of reach of children.
5.
Unplug the iron from the mains electrical supply before:
1）Cleaning
2）Filling with water or emptying the water tank
3）Immediately after use
SI-35
6.
Never operate the iron with damaged power cord or plug, or after it has fallen or
been damaged in any way. To avoid the risk of electric shock, do not disassemble
the iron, take it to a qualified serviceman for examination and repair.
7.
Do not let cord touch hot surfaces.
8.
To protect against a risk of electric hazards, do not immerse the iron in water or
any other liquid.
9.
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person to avoid a hazard.
10.
The iron must not be left unattended while it is connected to the mains supply.
11.
The plug must be removed from the sock-outlet before the water reservoir is filled
with water.
12.
The iron must be used and rested on a stable surface.
13.
When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
14.
The iron is not to be used if it has been dropped if there are visible signs of
damage or if it is leaking.
Advertisement
Table of Contents
Related Manuals for Russell Taylors SI-35
Summary of Contents for Russell Taylors SI-35
- Page 1 2）Filling with water or emptying the water tank 3）Immediately after use SI-35 Never operate the iron with damaged power cord or plug, or after it has fallen or been damaged in any way. To avoid the risk of electric shock, do not disassemble the iron, take it to a qualified serviceman for examination and repair.
- Page 2 Cautions of the first use: Indicator light: The iron has been greased, and as a result, the iron may slightly smoke when Plug in the iron, the power indicator light turns on, when the thermostat is heating switched on for the first time. After a short while, this will cease. up, the heating indicator light turns on, once the thermostat reaches the desired Before using for the first time, remove any sticker or protective foil from the...
- Page 3 Spraying Methods: Fill the water in the iron as per water-filling methods. Vertical steam Ironing Press water spray button. The vertical steam ironing system allows you to use the iron for vertical ironing. This is Note: No matter what steam ironing of dry ironing is, spray will always be available especially useful for getting wrinkles out of hanging clothes, curtains etc..
- Page 4 Hold the iron in a horizontal position above the sink. Press and hold the Self-Clean the MAX position with steam regulator in MAX position until Power Indicator Light goes button. off. Unplug from the mains socket and allow to cool. Clean the plate with a dry cloth as Steam and boiling water will start to come out of the iron plate holes, which traces of moisture could mark it.
- Page 5 Leaking Set the thermostat dial out of Set the thermostat dial as water from steam range per steam range soleplate The heat is still not enough Open steam button only after the indicator light goes off The water is over than max Pour out the remaining water position Little steam...
Need help?
Do you have a question about the SI-35 and is the answer not in the manual?
Questions and answers