Subscribe to Our Youtube Channel
Related Manuals for Teleste TEN-FWB7
Summary of Contents for Teleste TEN-FWB7
- Page 1 FTTx SOLUTIONS Compact FTTH Interface Box TEN-FWB7 Installation Guide Rev. 1.00/02.2024...
-
Page 2: Table Of Contents
FTTx Solutions Contents Getting Started............................1 Introduction ............................1 Package Contents ..........................1 About the TEN-FWB7 Fibre Outlet .......................2 Product Specification ........................... 2 Mechanical Layout ..........................2 Installation Instructions .........................3 General Preparations and Precautions ....................3 Installation Guidelines ......................... -
Page 3: Getting Started
The box has been specifically designed to facilitate a quick and seamless FTTH roll-out. We appreciate your choice! Package Contents Kindly unpack the TEN-FWB7 and confirm that all items are present, as illustrated in Figure 1. Should any items be missing, please promptly contact your local seller for assistance. -
Page 4: About The Ten-Fwb7 Fibre Outlet
FTTx Solutions About the TEN-FWB7 Fibre Outlet The splice tray of the TEN-FWB7 can accommodate up to 8 fusion heat shrink splice protectors. Additionally, it can be equipped with PLC 1:2 or 1:4 splitters. -
Page 5: Installation Instructions
TEN-FWB7 Installation Guide Rev. 1.00/02.2024 e n l i g h t e n FTTx Solutions Installation Thank you for choosing this Teleste product. Please take a moment and carefully read these instructions through before installing the product. Instructions General Preparations and Precautions 1. - Page 6 TEN-FWB7 Installation Guide Rev. 1.00/02.2024 e n l i g h t e n FTTx Solutions All necessary safety instructions must be followed during the installation and maintenance operations. The safety requirements for class 1M lasers are detailed in EN60825-1.
- Page 7 TEN-FWB7 Installation Guide Rev. 1.00/02.2024 e n l i g h t e n FTTx Solutions 3. After stripping the incoming cable, secure it to the top right corner bracket, see Pictures 4. Then route the fiber onto the tray, coil and adjust the length as you prefer to fit the splice holders, see Picture 5.
- Page 8 TEN-FWB7 Installation Guide Rev. 1.00/02.2024 e n l i g h t e n FTTx Solutions 4. Now its time to enter with the FTTH subscriber distribution cable. Make a tiny hole in the rubber gasket, press the cable through the rubber gasket.
-
Page 9: Mounting Guidance
TEN-FWB7 Installation Guide Rev. 1.00/02.2024 e n l i g h t e n FTTx Solutions Mounting Guidance Position the box on the wall and mark the screw holes, as shown in the image to the left. Then, drill holes in the wall and insert expansion plugs (depending on the wall’s material, you may not need expansion bolts). -
Page 10: Legal Declarations
This document is protected by copyright laws. Unauthorized distribution or reproduction of this document is strictly prohibited. Teleste reserves the right to make changes to any of the products described in this document without notice and all specifications are subject to change without notice. - Page 11 Teleste reserves the right to make changes to any features and specifications of the products without prior notice. Although the information in this document has been reproduced in good faith, the contents of this document are provided “as is”. Teleste makes no warranties of any kind in relation to the accuracy, reliability or contents...
Need help?
Do you have a question about the TEN-FWB7 and is the answer not in the manual?
Questions and answers