1. Manuals
  2. Brands
  3. DIG Manuals
  4. Handsets
  5. LEIT MULTI-PRO
  6. Instruction manual

DIG LEIT MULTI-PRO Instruction Manual

Two-way remote-control handset
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
LEIT MULTI-PRO
Two-Way
Remote-Control Handset
I N S T R U C T I O N
M A N U A L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LEIT MULTI-PRO and is the answer not in the manual?

Questions and answers

Related Manuals for DIG LEIT MULTI-PRO

Summary of Contents for DIG LEIT MULTI-PRO

  • Page 1 LEIT MULTI-PRO Two-Way Remote-Control Handset I N S T R U C T I O N M A N U A L...

  • Page 2: Table Of Contents

    Setting Up the Handset and LEIT XRC Controller .......... 3 Model Communication Software Protocol ..............LEIT MULTI-PRO TWO-WAY REMOTE-CONTROL HANDSET operates 99 controllers in one group • Charging the Handset ................Setting Up the Handset ................The LEIT Remote Control Handset is a 2-way radio communication device that operates in the Communicating with a LEIT XRC Controller ............

  • Page 3: Handset

    The Battery Voltage screen will flash at lower voltage and *LOW* will flash at critical voltage shortage. A car charger model 30-722 can be INTRODUCTION TO YOUR LEIT MULTI-PRO HANDSET purchased if needed. LEIT HANDSET COMPONENTS 6.

  • Page 4: Charging The Handset

    CHARGING THE HANDSET To set the time for the handset, underscore the appropriate The +++Charging+++ screen appears within one minute +++Charging+++ Time: 01 :37 EM digits using or ► . Press '1.s or � to change the after the DC charger is plugged in and the handset <...

  • Page 5: Communicating With A Leit Xrc Controller

    These screens show the user the controller's actual status. In these screens you can review how many valves the controller has, if any of the programs are active, if any valve is open, if manual The Uplink Radio screens allow the LEIT Link handset to to a LEIT XRC controller in just a few on, if the controller is being used with the LEIT key and if any other handsets are active.

  • Page 12: Service Call (Installation Troubleshooting)

    To communicate, the controllers and handsets MUST have the same Client Code. This is the user's unique identification code, which prevents interference from other users in the area. For LEIT Multi-Pro handsets, only one group, is permissible therefore all controllers must be set to group 1 (default).

  • Page 13: Programming Problems

    Then repeat the manual run and then check the All adjustments and changes must be made at DIG's facility under the specific guidelines set forth status. If there is an open circuit (wire break) it will be reported. Repeat with the short in our manufacturing processes.
  • Page 14 RECORD / CHART Controller Group Location Website: http://www.digcorp.com e-mail: dig@digcorp.com 1 21 Activity Drive 031725 DIG CORP 26-401 Vista, CA 92081, USA Printed the USA...

Table of Contents