ProBreeze PB-F-21 Important Instructions Manual page 4

PARTS
― ―
1. Fan Blades
2. Safety Grill
3. On/Off & Speed Controls
4. Rubber Feet
5. Stand
6. Motor
7. Cord Storage Hooks
8. Power Cord & Plug
9. Safety Screw
10. Secure Clips (5)
11. Carry Handle
12. Adjusting Nuts
These images are for reference only, please refer to your product.
If you find you're missing any parts from your order, please contact our customer care team by
emailing help@probreeze.com for fast and friendly help.
SET-UP
― ―
1. Place the fan on a flat level floor.
2. Adjust the fan to the desired angle. It may be necessary to tighten the nuts on either side of
the fan to secure the position.
3. Connect the fan to a power outlet.
4. Turn fan on.
WARNING: DO NOT MOVE OR ADJUST THE ANGLE OF THE FAN WHILE IT IS ON.
ON/OFF AND SPEED CONTROLS
― ―
Use the control at the back of the fan to control the speed and turn the fan On and Off.
0 – Off
1 – Low Power
2 – Medium Power
3 – High Power
6 of 10 | English
ANGLE ADJUSTMENT
― ―
To make adjustments to the angle of the fan, switch it off and adjust it to the desired angle using
minimal force, to not damage the fan.
If the fan does not adjust using minimal force, slightly loosen the adjusting nuts at the side of the
fan by turning it anti-clockwise. Adjust the fan to the desired angle and tighten again by turning
the clockwise.
CLEANING AND STORAGE
― ―
WARNING: ALWAYS TURN THE APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE APPLIANCE, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS THIS WILL DAMAGE THE APPLIANCE.
To clean the blades and interior of the fan:
1. Unclip the secure clips around the rim of the safety grill.
English | 7 of 10