To Clean And Examine The Product Parts; To Connect The Common Service Tool (Cst) - Husqvarna 585 Workshop Manual

1. Cylinder cover
2. Starter unit
3. Front handle
4. Chain brake and front hand guard
5. Air filter
6. Start/stop switch
7. Rear handle
8. Right hand guard
9. Carburetor
10. Centrifugal clutch
11. Clutch drum
12. Chain catcher
13. Guide bar bolts
14. Clutch cover
15. Heat shield
16. Muffler
17. Ignition system
18. Flywheel
19. Crankcase
20. Crankshaft
21. Vibration damping units
14 - Repair instructions
17
18
20
19
21

7.2 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.

7.3 To connect the common service tool (CST)

Note: I can be necessary to install firmware to a new
spare part. Make sure that you know the Husqvarna
identification number (HID) of the new spare parts
before you connect the product to common service tool
(CST). The identification number is found on the spare
part.
1. Start the common service tool (CST).
2. Connect the common service tool (CST) to the
product with cable.
a) Connect the correct adapter cable to the
common service tool (CST).
1624 - 004 - 02.11.2021