Chefman Custom-Temp RJ11-18-CTI-V2 Instructions Manual page 8

Before First Use
To rinse the pot of any packing debris, "brew" a pot of plain water without tea.
To do so, follow the directions below.
1.
Remove all packing materials. Be sure that all parts are included before
discarding any packaging.
2.
Pull out the power cord from the compartment under the base, and place
the base on a fl at surface. (Make sure the power cord comes out of the
opening in the base so the unit can sit level.)
3.
To rinse the pot of any manufacturing residue, "brew" a pot of plain
water without tea. To do so, lift off the lid and fi ll the kettle with water to
the MAX line.
4.
Put the lid with the infuser attached (but empty) back on the kettle.
Place the kettle on the base unit, and plug it into a power outlet.
5.
To switch between Fahrenheit and Celsius, if desired, press and hold the
SET TEMP button for 3 seconds. Turn the kettle on by pressing START | STOP.
The red LED lights inside the kettle will illuminate to indicate the water
is heating.
6.
Once the kettle boils, empty it (discarding the water), then rinse it with
fresh water.
RJ11-18-CTI-V2_UG_LIVE_032125.indd 8 RJ11-18-CTI-V2_UG_LIVE_032125.indd 8
8 8
3/21/25 3:17 PM 3/21/25 3:17 PM