Replacing The Power Distribution Board; System Board; Removing The System Board - Dell PowerEdge T310 Hardware Owner's Manual

Replacing the Power Distribution Board

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Align the securing slots on the power distribution board with the
tabs on the chassis.
2 Slide the board down until the blue release pin locks into place.
3 Connect all the power cables to the system board.
4 Replace the power supplies. See "Installing a Redundant Power Supply" on
page 104.
5 Close the system. See "Closing the System" on page 86.
6 Place the system upright on a flat surface.
7 Reattach any peripherals and connect the system to an electrical outlet.
8 Turn on the system and attached peripherals.

System Board

Removing the System Board

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
CAUTION:
key, you may be prompted to create a recovery key during program or system
setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or
program before you can access the encrypted data on your hard drives.
142
Installing System Components
Many repairs may only be done by a certified service technician.
Many repairs may only be done by a certified service technician.
If you are using the Trusted Program Module (TPM) with an encryption