Installing An Expansion-Card Riser - Dell PowerEdge R210 Hardware Owner's Manual

Figure 3-8. Installing or Removing an Expansion-Card Riser
1 release tab
3 expansion-card slot
5 expansion-card riser connector

Installing an Expansion-Card Riser

1 Align the expansion-card riser with the riser guide posts on the system
board. See Figure 3-8.
2 Lower the expansion-card riser into place until the expansion-card riser
connector is fully seated.
3 If applicable, reinstall the expansion card. See "Installing an Expansion
Card" on page 72.
4 Close the system. See "Closing the System" on page 63.
5 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1
5
2
4 riser guide posts (2)
Installing System Components
2
expansion-card riser
3
4
75