TTS Blue-Bot TacTile Reader User Manual page 2

How do I pair Blue-Bot or Rugged Robot to the Tactile Reader?
Follow these simple steps to connect Blue-Bot or Rugged Robot to a tactile code reader:
1. On the underneath of the Tactile Code Reader (see picture below) is the 'Power' and
'Sound' switch. Slide the 'POWER' switch to the 'ON' position. If sound is required, also
slide the 'SOUND' switch to the 'ON' position.
• A switch is turned on if it is next to the 'I' symbol on the underneath of the Tactile
Reader.
• A switch is turned off if it is next to the 'o' symbol on the underneath of the Tactile
Reader.
2. Next, turn on the bots:
For Blue-Bot:
• Slide the 'POWER' switch to the 'ON' position.
• Slide the 'SENSOR' switch to the 'ON' position. This will enable Bluetooth.
• If sound is required, ensure the 'SOUND' switch is also set to 'ON'.
For Rugged Robot:
3. Ensure that the Blue-Bot/Rugged Robot is within 10m of the Tactile Reader, to pair
successfully.
4. Hold down the blue 'Pairing' button. The Status LED (see picture below) will flash blue
while it is connecting and then will turn solid blue once connected. Blue-Bot's eyes will
glow solid blue when paired with the Tactile Code Reader. Rugged Robot's LED ring will
also glow blue when it is paired.
Status LED