NSL Outdoor Streamline SL-OD-RGB30K-20-BA8 User Manual

DESCRIPTION
This manual is for NSL's Outdoor rated
RGBW LED Strip Lights. Designed
specifically for Indoor and outdoor
lighting and decoration. The LED strip is
widely used in homes, offices, and
commercial spaces. With flexible
installation options and 16m+ color
options it offers users an efficient,
energy-saving, and long-lasting lighting
solution.
STEPS FOR INSTALLATION
01
Before installing, please turn off the power
supply of the lighting panel circuit.
02
Measure the length of the surface where
the LED strip is installed.
03
Cut the light strip into the required length.
Be sure to use sharp scissors and cut
directly on the marked cutting line.
04
After cutting, use silicone sealant to fill the
end cap, slowly insert the light strip into the
end cap, move it back and forth several
times, and then insert the light strip into the
bottom of the end cap to ensure a sealed
end cap (allow to dry overnight).
303 926 1100 nslsales@nslusa.com
National Specialty Lighting 2299 Kenmore Avenue, Tonawanda, New York, 14207
APPLICATIONS
• Aisle and stairway lighting
• Cabinet and Cove lighting
• Deck and patio lighting
• Pathway lighting
• Building facades and outlines
• Back lighting
• Showcase lighting
• Linear decorative lighting
05
Clean the installation surface and make
sure the surface to be installed is smooth
and free of any dust or oil stains.
06
Gently pull off the centrifugal paper of the
double-sided adhesive on the back of the
LED strip, and stick the light strip to the
surface where it needs to be installed.
07
Do not tear off all the centrifugal paper at
once. You need to peel and stick it at the
same time, and gently press both sides of
the PCB to ensure a firm adhesion. Be
careful not to press on the LED and other
components on the mounting surface .
www.nslusa.com
User Manual
Outdoor Streamline Series
SPECIFICATIONS
Product Code
Input Voltage:
CCT:
Operating Temperature:
Beam angle:
IP Grade:
Warranty:
LED tests:
CRI:
08
NOTE: For porous surfaces that will not allow a firm grip with the self
adhesive backing, we recommend that you use our U channel (SL-
RGBW-EX-39) or our mounting clips (SL-RGBW-MC) which can be
screwed to the surface first.
• Pay attention to the input voltage of the LED strip and do not exceed this
voltage.
• NOTE: The total power of the LED strip cannot be greater than the power
supply power (preferably less than 85% of the power supply power).
• NOTE: Please disconnect the circuit first when connecting the light strip.
• NOTE: In outdoor situations, Power supplies, controllers and repeaters
must be placed in weather proof enclosures.
For more information on extrusions, accessories or
specific LED products please use the QR code
below.
SL-OD-RGB30K-20-BA8
DC24V
RGB3000k
( -20°C~40°C)
140°
IP65
5 years
LM80
CRI>90
WARNING
P1