Future Design xplode Manual page 13

EN
xplode
INSTRUCTION FOR USE
USAGE
1. OPEN THE FRAME OF STROLLER
Push the lock to the outside of the stroller and pull up the handle as the
arrow direction to open the stroller until you hear the "click" sound on both
side of the stroller, please examine if the stroller is locked in safety position
before you use it.
2. ASSEMBLE/DISASSEMBLE THE BUMPER
Insert the bumper on both sides of the seat, please make sure to lock the
bumper in place when you heard "click" sound. Press the buttons on both
sides of the bumper at the same time, and pull up the bumper to take off it.
Unlock and pull out one side of the bumper to rotate it in 360 degrees.
3. ASSEMBLE/DISASSEMBLE THE CANOPY
Insert the hood plastic into the plastic mounting fixed on the frame, and pull
out the canopy tube to open it. You can open the zipper puller to make the
canopy fully unfolded and bigger.
4. ASSEMBLE/DISASSEMBLE THE FRONT WHEELS
Take the front wheels and insert the vertical shaft into the plastic hole on
the wheel housing, until you heard the "click" sound and make sure they
are locked by pulling the wheel down.
Press the small metal pins and pull out the front wheel to disassemble
the front wheels. Lift down the little plastic button on the front wheel
housing in any angle, then push the stroller to roll forward - position the
front wheels will lock in front facing direction. Lift up the button to
release the front wheels swivel and it can rotate in 360 degrees.
5. ASSEMBLE/DISASSEMBLE THE REAR WHEELS
Insert the rear wheels into the plastic mounting holes on the rear housings
until you heard the "click" sound and make sure they are locked.
Pull the rear wheel lock pin and at the same time pull out the rear wheel in
the direction of arrow, then finish the disassemble.
6. USING THE BRAKES THE STROLLER
Step down the brake pedal to brake the stroller, lift up the pedal to release
the brake.
12