Download
Share
Print this page
  1. Manuals
  2. Brands
  3. makute Manuals
  4. Paint Sprayer
  5. SG122
  6. Instruction manual

makute SG122 Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
SPRAY GUN
SG122

Advertisement

loading
Need help?

Need help?

Do you have a question about the SG122 and is the answer not in the manual?

Questions and answers

Related Manuals for makute SG122

Summary of Contents for makute SG122

  • Page 1 SPRAY GUN SG122...

  • Page 2: Suction Tube

    .com IV How to use: Before use the electric spray gun, material preparation is the first stage. Please refer to the thinning chart and picture. Material Run Out Time (Sec) 1) Unscrew the paint container from the spray gun.
  • Page 3 .com a) If spray in an upward direction，the angled end of the suction tube should be pointing toward the rear of the gun. Suction Tube b) If spray in a downward direction, the angled end of the suction tube should be pointing towards the front of the gun.
  • Page 4 .com 5) Connect gun body with motor a) Hold the gun with your hand to align the slot on the gun with the slot on the motor and insert it (as shown in the figure). b) Hold the motor handle with your hand, rotate the right hand clockwise 90°.
  • Page 5 .com 7) Spray length adjustment: Turn this knob to adjust the round shape from vertical to horizontal. Adjust the required length according to the spraying environment, reduce waste and save material. a) The counterclockwise rotation shortens the length, and when it rotates to the stop position, it is sprayed with the largest circle.
  • Page 6 .com 8) Adjusting spray patterns a) The gun spray patterns can be changed from a horizontal oval fan pattern to a round b) detailed pattern to a vertical fan pattern by adjusting the nozzle. VERTICAL HORIZONTAL 9) Open the power switch, pull trigger, the paint will spray from the nozzle.
  • Page 7 .com VI Replace nozzle and Needle: When disassembling the nozzle, please pull the trigger first, then press and remove the nozzle. a) As shown in the figure, rotate to remove the needle b) As shown in the figure, rotate to set up the needle...

  • Page 8: Troubleshooting

    .com VII Troubleshooting: Problem Cause Solution Problem Cause Solution A.little or no material flow 1.nozzle clogged 1.clean 2.suction tube clogged 2.clean 3.material volume setting 3.turn to the left turn too far to the right 4.suction tube loose 4.insert 5.material is too thick 5.check viscosity...
  • Page 9 .com...