Related Manuals for DEL ROLLEASY 2
Summary of Contents for DEL ROLLEASY 2
- Page 1 INSTALLATION GUIDELINES INSTALLATION/SERVICING/MAINTENANCE/SAFETY ADVICE ABOVE-GROUND COVER ROLLEASY 2...
-
Page 2: Table Of Contents
CONTENTS PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE Please read this manual carefully to help you understand all of the information and to ensure safe installation, use and servicing. We cannot be held liable for any damage arising due to a failure to respect the instructions set out in this manual. -
Page 3: Information
INFINITY kit to automatically lower the water level by at least 2cm when the pool cover is closed. • Currently, DEL covers including a removable slats for step unit on the length to go over a ladder do not comply with standard NF P90-308 •... -
Page 4: Description
DESCRIPTION COMPONENTS PROVIDED • The motor (which complies with electrical standards) is located in the tube and can be accessed from inside the end- stand.. • The “mechanical end switches” that allow the slats to be stopped when it has been fully unwound or wound onto the pole can be calibrated directly on the motor. - Page 5 DESCRIPTION COMPONENTS PROVIDED Free Electrical Motorised rewinding Manual rewinding Solar-powered Manual terminal terminal pole pole terminal terminal Electrical version Manual version Solar-powered Solar-powered version version battery Control box wheel Motor battery charger MOUNTING PACKING FOR ELECTRICAL OR SOLAR-POWERED VERSION M8x80 Allen key TF bolt Ø12...
-
Page 6: Tools Required For Mounting
DESCRIPTION TOOLS REQUIRED FOR MOUNTING PACKING LIST MOUNTING Example for a 4x8m pool: 2 people 1 parcel - 0.80 x 0.60 x 0.55m 40kg 1 parcel - 4.30 x 0.20 x 0.20m 25kg 4 parcels - 4.10 x 0.25 x 0.20m 150kg Total weight : 215kg 3 hours... -
Page 7: Installation
INSTALLATION ROLLER MOUNTING AND FASTENING MOUNTING OF TERMINAL Remove the door of the terminals only for electrical and solar-powered versions motor side M6 nut TBHC bolt M6x30 M8 nut THEF bolt M8x30... - Page 8 INSTALLATION MOUNTING AND POSITIONING OF THE ROLLER WITH REGARD TO THE POOL Manual version Solar-powered and electrical version Pole Wheel side Motor side 20mm Motor side Motor side Centre of pool A = B Rounded or cut-off Filtration block corners 60cm max 60cm max Sharp corners...
- Page 9 INSTALLATION GROUND MOUNTINGS FOR ROLLER M8 Ø24x2 Ø12 M8x80 washer Rawlplug Step bolt Ø12 Solar-powered and electrical version...
- Page 10 INSTALLATION INSTALLATION OF THE MOTOR (ELECTRICAL AND SOLAR-POWERED VERSION) M6 nut M6 Ø12x1.2 M6 wavy washer washer align the pin with the slot Make gentle rotating movements with the motor to ensure it fits snugly into its housing.
-
Page 11: Control Box
INSTALLATION CONTROL BOX The electrical connection of the equipment must only be carried out by a qualified professional, and they must comply with the manufacturer’s instructions in addition to the following applicable standards and regulations: - NF C15-100: Low voltage electrical installations - CEI 60364: Electrical installations for buildings Please refer to the leaflet enclosed with the control box to ensure correct installation. -
Page 12: Solar Panels
INSTALLATION SOLAR PANELS To avoid potential breakage of the solar panel during transport, we have installed them on the inside of the door. They must therefore be mounted on the outside as shown below. Tighten by hand and stop on contact... -
Page 13: Wiring For Electrical Version
INSTALLATION WIRING FOR ELECTRICAL VERSION RO2V in conduit) 2 x 6mm - up to 25m long 230 V... -
Page 14: Wiring For Solar-Powered Version
INSTALLATION WIRING FOR SOLAR-POWERED VERSION... -
Page 15: Setting
INSTALLATION Any person carrying out work on the electrical parts must be qualified and wear PPE (personal protective equipment): gloves, goggles, mat, etc. Warning: use of the pool cover control buttons present in the housing (Wi-Key receiver) must only be carried out by a person who is absolutely certain that there is no risk and that no-one will enter the pool during the operation. -
Page 16: Servicing/Maintenance
SERVICING/MAINTENANCE POOL WATER LEVEL • In order to ensure maximum safety and correct operation of the Roller, always check that the water level in the pool remains constant and complies with the manufacturer’s requirements (for greater comfort, use an overflow and a water level regulator). -
Page 17: Battery
SERVICING/MAINTENANCE BATTERIES At the first sign of the batteries losing power, recharge them. NEVER LET THE BATTERIES LOSE COMPLETELY THEIR CHARGE. Connect the batteries to the charger (check the polarity). Plug the charger in. It will switch on automatically to the correct voltage and the charging process will begin. -
Page 18: Roller Clutch
SERVICING/MAINTENANCE ROLLER CLUTCH If the motor breaks down or if there is a power cut, you can remove the motor in order to close the pool manually. Cut off electrical power Disconnect the motor Remove the mountings and pull out the motor Unroll the slats manually Attach the fastening kit... -
Page 19: Safety Advice And Standards
SERVICING/MAINTENANCE WINTERING • Position the cover in the closed position and keep the water level constant in accordance with the manufacturer's recommendations. Between 7 and 15 cm • During the winter season, in the event of snowfall, it is essential to remove snow from the roof using a brush with a telescopic handle. -
Page 20: Fire Service
SAFETY ADVICE Please read the recommendations set out below with care. WARNING Swimming pools can represent a serious danger for your children. Drowning can happen very quickly. Children who are close to a swimming pool need to be watched constantly and actively, even if they know how to swim. - Page 21 SAFETY ADVICE • This cover is by no means a replacement for common sense or individual responsibility. Its aim is not to replace the vigilance of parents and/or responsible adults, who remain the essential factor in ensuring the protection of young children. •...
-
Page 22: Recycling
RECYCLING PACKAGING Dispose of the packaging in line with current rules and regulations. END OF LIFECYCLE • Do not put your scrapped equipment or used batteries in with unsorted household waste. • You are responsible for disposing of all of your waste, in particular electrical and electronic equipment by taking it to a collection point where recycling and valorisation are carried out. -
Page 23: Warranty Condition
REGULATIONS STANDARD • This cover complies with standard NFP 90-308. WARRANTY CONDITION log on to www.del-piscine.fr to consult all our guarantees. https://www.del-piscine.fr/rechercher-une-garantie... - Page 24 DEL SAS ZA LA BASSE CROIX ROUGE 35530 BRÉCÉ - FRANCE +33 (0)9 70 72 5000 / INFO.FR@ CF.GROUP STAMP A brand by CF group...
Need help?
Do you have a question about the ROLLEASY 2 and is the answer not in the manual?
Questions and answers