Advertisement
Advertisement
Table of Contents
Related Manuals for UNIVIEW GCB01-B7
Summary of Contents for UNIVIEW GCB01-B7
- Page 1 Connect Box Quick Guide V1.00...
-
Page 2: Packing List
Packing List Contact your local dealer if the package is damaged or incomplete. The package contents may vary with device model. Name Unit Connect box 12V power cable Anti-drop protective case Lanyard Overview The connect box is intended to improve the installation and commissioning efficiency of cameras, and provide solutions to common construction problems, such as IP address modification, temporary power and network supply, voltage detection, etc. -
Page 3: Appearance And Interfaces
Appearance and Interfaces The appearance and interfaces may vary with device model. The figure below is only for illustration. Connect a lanyard Item Description System indicator: Steady on after powering on Wi-Fi indicator: Steady on after enabling hot-spot; Blinking when transmitting data Battery indicator: Show the current battery level after turning on Low battery. -
Page 4: Device Management
NOTE! • Press the Reset button and hold for at least 10 seconds to restore the default Wi-Fi configuration. • When the power switch is ON, long press to turn off the box. Press the button again to turn on the box. CAUTION The DC12V output and PoE output cannot be used at the same time. -
Page 5: Copyright Statement
People's Republic of China and the United States, and abides by relevant regulations relating to the export, re-export and transfer of hardware, software and technology. Regarding the product described in this manual, Uniview asks you to fully understand and strictly abide by the applicable export laws and regulations worldwide. - Page 6 To the extent allowed by applicable law, in no event shall Uniview’s total liability to you for all damages for the product described in this manual (other than as may be required by applicable law in cases involving personal injury) exceed the amount of money that you have paid for the product.
- Page 7 Verify that the device is properly installed before connecting it to power. Do not remove the seal from the device body without consulting Uniview first. Do not attempt to service the product yourself. Contact a trained professional for maintenance.
-
Page 8: Regulatory Compliance
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Visit http://en.uniview.com/Support/Download_Center/Product_Installation/Declaration/ for SDoC. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the GCB01-B7 and is the answer not in the manual?
Questions and answers