Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HiLook HL-HA-KIT-A2
Summary of Contents for HiLook HL-HA-KIT-A2
- Page 1 Four-Wire Bundle User Manual...
-
Page 2: Symbol Conventions
Four-Wire Bundle User Manual Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Indicates a hazardous situation which, if not avoided, will or could Danger result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, could Caution result in equipment damage, data loss, performance degradation, or unexpected results. -
Page 3: Safety Instruction
Four-Wire Bundle User Manual Safety Instruction Warning All the electronic operation should be strictly compliance with the electrical safety regulations, ● fire prevention regulations and other related regulations in your local region. Please use the power adapter, which is provided by normal company. The power consumption ●... - Page 4 Four-Wire Bundle User Manual Improper use or replacement of the battery may result in hazard of explosion. Replace with the ● same or equivalent type only. Dispose of used batteries according to the instructions provided by the battery manufacturer. Input voltage should meet both the SELV and the Limited Power Source according to 60950-1 ●...
-
Page 5: Regulatory Information
Four-Wire Bundle User Manual Regulatory Information EU Conformity Statement This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable harmonized European standards listed under the EMC Directive 2014/30/EU, RE Directive 2014/53/EU,the RoHS Directive 2011/65/EU 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. - Page 6 Four-Wire Bundle User Manual Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité...
-
Page 7: Table Of Contents
Four-Wire Bundle User Manual Contents Chapter 1 Wiring Description of the Bundle ................1 Chapter 2 Introduction of Indoor Station ..................5 2.1 Appearance ..........................5 2.2 Wall Mounting ........................5 2.3 Introduction of Buttons ......................7 2.4 Parameter Configuration ......................8 Chapter 3 Introduction of Door Station .................. -
Page 8: Chapter 1 Wiring Description Of The Bundle
Four-Wire Bundle User Manual Chapter 1 Wiring Description of the Bundle The system supports 3 typical applications. The pictures are shown as below. Caution Make sure all the related equipment is power-off during the wiring and installation. Note Up to 2 door stations and 3 indoor stations can be used in one video intercom system. ●... - Page 9 Four-Wire Bundle User Manual Typical Application 1: 1 Door Station and 1 Indoor Station Figure 1-2 Typical Application 1...
- Page 10 Four-Wire Bundle User Manual Typical Application 2: 1 Door Station and 3 Indoor Station Figure 1-3 Typical Application 2...
- Page 11 Four-Wire Bundle User Manual Typical Application 3: 2 Door Stations and 3 Indoor Stations Figure 1-4 Typical Application 3...
-
Page 12: Chapter 2 Introduction Of Indoor Station
Four-Wire Bundle User Manual Chapter 2 Introduction of Indoor Station 2.1 Appearance Figure 2-1 Appearance Table 2-1 Description Description Display Screen Buttons (Call/Unlock/Live View/Switch Camera) Microphone Loudspeaker Four-Wire Interface DIP Switch Camera Interface Power Interface Debugging Port (for debugging use only) 2.2 Wall Mounting The device supports wall mounting. - Page 13 Four-Wire Bundle User Manual Before You Start Make sure the device in the package is in good condition and all the assembly parts are included. ● Please make sure your power supply matches your indoor station. ● Make sure all related equipments are power-off during the installation. ●...
-
Page 14: Introduction Of Buttons
Four-Wire Bundle User Manual Figure 2-3 Wall Mounting 2.3 Introduction of Buttons The introduction of buttons are as follows. -
Page 15: Parameter Configuration
Four-Wire Bundle User Manual Figure 2-4 Buttons Call Button You can press to receive or hang up the call. Unlock Button You can press to unlock the door. Live View Button You can press to view the live videos of door stations or analog camera. Switch Camera Button You can press to switch between door station 1 or 2 or analog camera when viewing live... - Page 16 Four-Wire Bundle User Manual Figure 2-5 Local Configuration You can select ringtone, adjust volume, set duration of remaining open, set volume of door stations, adjust the brightness and check the information of the device. Select the ringtone of the device. Adjust the volume of the device.
-
Page 17: Chapter 3 Introduction Of Door Station
Four-Wire Bundle User Manual Chapter 3 Introduction of Door Station 3.1 Appearance Figure 3-1 Appearance Table 3-1 Description Description Camera Microphone Loudspeaker Call Button Debugging Port (for debugging use only) Four-Wire Interface Lock Interface... -
Page 18: Wiring Of Lock
Four-Wire Bundle User Manual 3.2 Wiring of Lock Figure 3-2 Lock Interface Figure 3-3 Lock Wiring... -
Page 19: Installation
Four-Wire Bundle User Manual 3.3 Installation Note Make sure the device in the package is in good condition and all the assembly parts are included. ● Make sure your power supply matches your door station. ● Make sure all the related equipment is power-off during the installation. ●... -
Page 20: Wall Mounting With Protective Shield
Four-Wire Bundle User Manual Figure 3-5 Dimension of Protective Shield The dimension of the protective shield is 79.57 mm × 149.8 mm × 48.64 mm. 3.3.2 Wall Mounting with Protective Shield Steps 1. Stick the mounting template on the wall. Drill screw holes according to the mounting template. Remove the template from the wall. - Page 21 Four-Wire Bundle User Manual Figure 3-6 Secure Accessories to the Wall 3. Wire the device and fix the device to the mounting plate. 4. Fix the device on the mounting plate with 1 SC-KM3X8-T10-SUS-NL set screw.
-
Page 22: Wall Mounting
Four-Wire Bundle User Manual Figure 3-7 Secure Device to the Wall 3.3.3 Wall Mounting Steps 1. Stick the mounting template on the wall. Drill screw holes according to the mounting template. Remove the template from the wall. 2. Secure the mounting plate on the wall with 4 SC-KA4X25 screws according to the screw holes. 3. - Page 23 Four-Wire Bundle User Manual Figure 3-8 Wall Mounting...
-
Page 24: Chapter 4 Local Operation
Four-Wire Bundle User Manual Chapter 4 Local Operation Before you start, you need to connect the indoor station and door station via the four-wire interface and then wire the indoor station with DC 12 V power adapter via the power interface. The indoor station and door station will be powered on. -
Page 25: Appendix A. Cables
Four-Wire Bundle User Manual Appendix A. Cables Cables and Wiring If you use two groups of parallel cables or twisted pairs instead of the supplied white four-wire cables for wiring, you should put the blue cable (video) and black cable (ground) in the same group of parallel cables or twisted pairs and put the yellow cable (audio) and red cable (power) in the same group. - Page 26 UD34981N...
Need help?
Do you have a question about the HL-HA-KIT-A2 and is the answer not in the manual?
Questions and answers