These instructions should be used to aid installation of the following products: EX1TWH / EX1TBK / EX3TWH / EX4TSS / EX5TMB SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
SAFETY This product must be installed in accordance with the latest edition of the IEE Wiring Regulations • (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician • Please isolate mains prior to installation or maintenance •...
Page 4
Fig. 2 Fig. 2 • If required, carefully remove the cable knock-out on the rear of the baseplate and guide If required, carefully remove the cable knock-out on the rear of the baseplate and guide the mains cable the mains cable through. Alternatively, the cable can be surface mounted via the cut-out •...
Page 5
surface mounted, the cable must be secured under the cable clamp provided Ensuring correct polarity is observed, wire as shown in Fig. 3 • Adjust the overrun timer with the aid of a small screwdriver, turn anti-clockwise to reduce (to a minimum •...
Page 6
• Check all electrical connections are secure with all exposed copper within the terminal and Check all electrical connections are secure with all exposed copper within the terminal and no loose • strands of cable no loose strands of cable Attach the front cover plate and secure with the screw (see Fig.
ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML...
Page 8
SUPPLIED BY: (UK) MANUFACTURER ML ACCESSORIES LTD, UNIT E CHILTERN PARK, BOSCOMBE ROAD, DUNSTABLE LU5 4LT, WWW.MLACCESSORIES.CO.UK (EU) AUTHORISED REPRESENTATIVE SLV LIGHTING GROUP, DAIMLERSTRASSE 21-23, 52531 ÜBACH-PALENBERG, GERMANY EMAIL: EPREL@GROUP.SLV.COM MADE IN CHINA 230V IP45 50Hz JBJULY24_V1...
Need help?
Do you have a question about the EX1TWH and is the answer not in the manual?
Questions and answers