Safety Features - Morphy Richards SPILLMASTER - AUTRE Instructions Manual

A
ASSEMBLY
Assembling the
SpillMaster
The SpillMaster may arrive in two
parts.
To assemble the product, align the
mark on the water tank with the
mark on the top unit. Push the two
parts together and rotate clockwise
until the top part clicks into place.
OPERATING THE
SPILLMASTER
Depending on your model of
cleaner, your SpillMaster may
require an adaptor.
If required, choose the appropriate
adaptor and fit as shown B.
B
Attaching the SpillMaster
C
to your vacuum cleaner
Assemble the vacuum cleaner
according to it's instruction booklet.
Ensure the vacuum cleaner is
switched off before attaching the
SpillMaster.
Attach the SpillMaster directly onto
the vacuum hose with adaptor if
required C.
It is not recommended to use any
extension tubes when using the
SpillMaster.
4
USING THE
SPILLMASTER
Turn the vacuum cleaner on.
A
Place the SpillMaster on the floor
and tilt forwards so the nozzle
touches the floor D.
D
You are now ready to pick up any
liquid spills.
The SpillMaster can be used on all
floor types but must only be used
for liquid spills. It has not been
designed to suck up solids.
For maximum effectiveness, use the
SpillMaster in a steady, slow
motion, pulling it towards yourself.
Always ensure the SpillMaster is
tilted forwards E.
E
Ensure only the nozzle touches the
floor, so the water tank is not
dragged through the liquid spill.
Backward strokes are more effective
on deeper carpets.
F

SAFETY FEATURES

As well as the hose filter, there are
three other main safety features F
which will cut off suction to the
SpillMaster in the event of improper
use:
If the SpillMaster is tilted
backwards, a slug in the nozzle
suction chamber will slide
backwards, blocking the suction to
the hose G.
If the SpillMaster is tilted sidewards,
a slug in the suction chamber
connecting to the liquid tank will
slide upwards, blocking the suction
in the unit G.
G
EMPTYING THE
SPILLMASTER
Ensure the vacuum cleaner power is
switched off.
If the SpillMaster is overfilled with Remove the vacuum hose from the
liquid, a float in the liquid tank will SpillMaster.
rise upwards, blocking the suction
in the unit. Take the SpillMaster to a sink or
drain to empty.
If any of the above occurs, turn off
your vacuum cleaner immediately, Press down on the tank release
empty the tank, reassemble the button with one finger H.
SpillMaster and resume use as
described in 'Using the SpillMaster' With the other hand, rotate the
section. handle section anti-clockwise as far
as possible H.
Pull upwards to separate the unit
into it's two parts.
Empty the contents of the reservoir
by tipping it upside down over a
sink or drain I.
Before safety
features activate
Safety features
activated
H
I
g
5