Morphy Richards LATITUDE AND FOOD FUSION FOOD PROCESSOR - REV 3 Manual page 6

48950 Rev 3 30/5/08
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 5 5 0 0
6 6
10:04 Page 6
Dough blade
1 Fit the processor bowl into
place as described in the
'Setting up' section.
2 Place the dough blade on the
detachable drive shaft. Then
place the ingredients in the
bowl.
3 Fit the lid and slot into place,
making sure that it clicks.
4 Now plug in the processor.
5 Turn the processor on and
operate until the dough has
formed into a small ball.
6 Remove the blade from the
bowl before removing the
dough.
IMPORTANT: When kneading
dough, do not operate the
machine longer than 30
seconds.
Afterwards, wait at least 2
minutes before operating the
machine again.
WARNING: For safety,
always leave the pusher in
place whilst operating the
processor.
Whisk attachment
1 Fit the processor bowl as
detailed previously in the
'Setting up' section.
2 Place the whisk attachment
onto the motor drive.
3 Add ingredients into the bowl.
4 Fit the lid and food pusher and
click into place as detailed in
the 'Setting up' section.
5 Plug in the processor.
6 Turn the processor on.
IMPORTANT: Never use the
whisk attachment for dough
kneading.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 6 6
Slicing & Chopping
There is a choice of blades for
slicing and shredding.
1 Fit the processor bowl as
before on the motor drive.
2 Fit the detachable drive shaft.
Place the blade of your choice
3
on top of the detachable drive
shaft, holding the blade by the
centre grip. Ensure that the
teeth are facing upwards.
WARNING: Use extreme
caution - the blades are
sharp.
4 Fit the lid and click into place
as detailed in the 'Setting up'
section.
5 Fit the large food pusher into
the tube on the processor lid.
6 Use the small food pusher to
add food into the processor
bowl through the feeder tube.
Mini processor bowl
Use the mini processor bowl to
chop herbs and small quantities
of ingredients.
1 Fit the mini chopping bowl on
the processor body, as detailed
previously in the 'Setting up'
section.
2 Slot the mini processor bowl
into the main processor bowl,
ensuring that the locators on
the processor bowl align with
the slots in the mini processor
bowl.
3 Using only the small blade,
place on top of the motor drive.
This fits in the hole in the mini
processor bowl.
4 Add the food.
5 Fit the lid, ensuring that it is
correctly located.
6 Operate the processor for 2 to
5 seconds only.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9