Advertisement
S2 Rev 2
21/7/04
1:49 PM
Switch control
fi
How to use
1 Ensure the blanket is fitted to the bed
correctly.
2 Plug the power lead into the closest
socket, using an extension lead if
needed to ensure that the lead is not
stretched.
Preheating the bed
1 Move the heat setting on the control
switch to heat level 3 or 4, depending on
the level of the heat required. Allow
approximately 60-90 minutes for the
blanket to heat the bed thoroughly,
although this time may vary depending
on the room temperature and type of
bedding used.
Page 5
Features
⁄ Illuminated heat setting light
¤ Heat levels 3 & 4
⁄
¤
‹ Heat level 1 & 2
‹
› Braille markings
›
fi Off position
All night use
1 Move the heat setting on the control
switch to heat level 1 or 2.
• This setting will provide safe and
comfortable heat to sleep on all night.
• This setting can be used to air the bed.
WARNING: Always ensure that the
heat setting is moved to the OFF
position when you get up the next day,
or after airing the bed.
Braille markings
• Braille markings are located on the back
of the switch to help identify the
direction of the heat level in the dark, or
if visually impaired.
• The highest heat level
pre-heat is identified by 3 raised nodules
mid level by 2 raised nodules
low level (all night) by 1 raised nodule.
5
(To identify heat levels in the dark)
(Used to pre-heat)
(Safe & comfortable to sleep all night)
(located on the back of the switch)
Advertisement
