Page 3
LAY-Z-SPA® OWNER’S MANUAL Visit www.bestwaycorp.com/support for help WE SUGGEST NOT TO RETURN THE PRODUCT TO THE STORE QUESTIONS? PROBLEMS? MISSING PARTS? For FAQ, Manuals, Videos Or Spare Parts, Please Visit bestwaycorp.com/support TABLE OF CONTENTS SAFETY INFORMATION Carefully read over the important safety instructions and warnings before operating and keep this manual for future reference. Failure to follow safety information can result in serious injury or death to users.
To check the parts included in the box, consult the part list on the package. Verify that the equipment components represent the model that you had intended to purchase. In case of any damaged or missing parts at the time of purchase, visit our website bestwaycorp.com/support. SETUP INSTRUCTIONS For the installation instructions, refer to the illustration steps on the package.
Page 5
WARNINGS - RISK OF ELECTRIC SHOCK TO AVOID ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS RAINING, THUNDERING OR LIGHTNING. Don't use extension cord to connect unit to electric supply; provide a properly located outlet. Don’t plug or unplug the appliance if your hand is wet. Never operate any electrical appliance when in your spa or when your body is wet.
Page 6
Continuous, active, and vigilant supervision of weak swimmers and non-swimmers especially in exercise spas, by a competent adult is required at all times (remembering that children under five years of age are at the highest risk of drowning). Designate a competent adult to supervise the spa each time it is being used. Weak swimmers or non-swimmers should wear personal protection equipment, especially when using the exercise spa.
Page 7
For safety reasons, only use the accessories provided or approved by the spa manufacturer. Regarding the information pertaining to the installation, refer to the following paragraph of the manual. Whenever the spa is emptied, the filter should be cleaned (and drained/dried, where applicable). Please examine equipment before use.
PRODUCT DESCRIPTION HOT TUB HEATER SPECIFICATIONS: Power Rate 220-240V AC, 50Hz, 2050W PARTS & TOOLS NEEDED Compare the parts in your box to the parts listed on the top of the package. Verify that the equipment components represent the model that you had intended to purchase.
The selected surface must be clear of aggressive plants and weed species. Types of strong vegetation could grow through the liner and create water or air leakage. Grass or other vegetation that may cause odor or slime to develop must be eliminated from the chosen location. The selected location must not have overhead power lines or trees.
Page 10
AIRJET WITH WI-FI AIRJET ON/OFF BUTTON: After activating the RCD/PRCD, press and hold the button for 2 seconds. The button will light up green and the control panel can now be used. Press and hold the button for 2 seconds to turn off all activated functions.
FOR WI-FI ENABLED HOT TUBS ONLY: WI-FI ACTIVATION: For Wi-Fi and smartphone app operation instructions, read the hot tub Wi-Fi instruction leaflet included in the package. THE WATER HEATER RATE MAY CHANGE IN THE CONDITIONS BELOW: When the outdoor temperature is below 15°C (59°F). If the cover is off or not in the correct position.
Page 12
LINER It is normal for your hot tub liner to appear as if it is losing air due to variations in ambient temperature that may change the internal air pressure in the liner. Follow the assembly instructions and inflate to the accurate pressure, when needed. When detaching the pump from the liner, to avoid water from coming out of the pipes, block the pipe by screwing on the cap and installing the stoppers on the debris screens.
To dry the different parts of the hot tub, follow the drawings. Drawings are for illustration purposes only. May not reflect actual product. Not to scale. After draining the hot tub, some water may remain in the pump, liner chamber, massage chain and inflatable cover. Make sure that all of these parts of the hot tub are completely dry.
Page 14
section. Clean/replace the filter cartridge Dirty filter cartridge. (refer to Filter Cartridge Cleaning and Replacement section). Hot tub is not covered properly with Properly attach the cover. lid. For assistance, please visit the Heating element failure. support section on our website, www.bestwaycorp.com.
Page 15
Press the button for 2 seconds if the problem persists. For assistance, please visit the Control panel is not activated. support section on our website, www.bestwaycorp.com. Insert the stopper caps on the hot Seals are missing inside the pump tub ports to prevent the water from adapters.
router. If the signal strength is full, repeat the procedures to connect the hot tub to the network. The Wi-Fi connectivity can be There is an appliance near the hot interrupted by electromagnetic or tub pump or the router that creates other interferences.
Page 17
Activate the filter or heat system and put your hand in front of the outlet pipe inside the pool to check if you can feel water flowing out. For assistance, please visit the If no water flows out, the water support section on our website, pump is broken.
Page 18
50°C (122°F). the pump and restart it when the water temperature reaches 38°C (100°F) or lower. Unplug and detach the pump and drain the hot tub. After 15 minutes, The ambient temperature is higher reattach the pump, plug it back in than 40°C (104°F) or the hot tub has and restart the heating function.
Connect the hot tub pump to a new socket or call an electrician to check The ground system of the wall the wall socket. If the problem socket where the hot tub is continues, we suggest creating an Ground connection failed. connected has a problem.
Need help?
Do you have a question about the AirJet and is the answer not in the manual?
Questions and answers