Advertisement
Styling Tips
Having shampooed your hair, ensure
that it is rinsed properly as shampoo that is
left in the hair will leave it looking dull.
To maximise shine, rinse your hair in
cool water thoroughly.
Comb your hair through with a wide
toothed comb to remove tangles before
styling.
Attachments
When using the twist and lift
attachment, use of a high heat/speed
setting may cause the automatic thermal
protection cut-out to operate and the
hairdryer will stop. Should this occur, switch
off the hairdryer and remove the plug from
the power socket. Allow to cool, the cut-out
will automatically reset, you can then
continue to dry your hair using a lower
speed.
Cool shot & boost button
Set your style in place with a flow of
cool air or use a boost of heat for quicker
styling.
Styling
Using the concentrator nozzle
Unclip nozzle for normal use.
The concentrator nozzle may also be
adjusted to allow more control over styling.
If you are blow drying curly hair into a
straight style, you need to concentrate the air
down into the shaft of the hair. Close the
unique adjustable nozzle up into the
narrowest position.
If you want to add more volume and
movement throughout the hair, open the
nozzle to its widest position.
Using the twist & lift
Ensure the hair is dried thoroughly before
you attempt to lift the roots. To add volume
TM
and lift, remove the concentrator nozzle if
attached and attach the twist and lift
motorised attachment. Toss the hair forwards
to loosen, then with the dryer on the desired
setting, place against the head, with the tips
of the rods touching the scalp and press the
twist and lift button, to move the dryer in an
oscillating motion. It will continue to oscillate
until the button is pressed again which will
turn the oscillating motion off.
3
TM
attachment
Advertisement
