1. Manuals
  2. Brands
  3. Q-SYS Manuals
  4. Speakers
  5. AD-C8T-ZB
  6. Hardware user manual

Q-SYS AD-C8T-ZB Hardware User Manual

Ceiling mount loudspeakers – zero bezel
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Hardware User Manual
AcousticDesign™ Series
AD-C8T-ZB, AD-C8T-SWZB, AD-C10T-HPZB
Ceiling Mount Loudspeakers – Zero Bezel
WA-001002-01-B
*WA-001002-01*
AD-C8T-ZB
AD-C10T-HPZB
AD-C8T-SWZB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AD-C8T-ZB and is the answer not in the manual?

Questions and answers

Related Manuals for Q-SYS AD-C8T-ZB

Summary of Contents for Q-SYS AD-C8T-ZB

  • Page 1 Hardware User Manual AcousticDesign™ Series AD-C8T-ZB, AD-C8T-SWZB, AD-C10T-HPZB Ceiling Mount Loudspeakers – Zero Bezel AD-C8T-ZB AD-C8T-SWZB AD-C10T-HPZB WA-001002-01-B *WA-001002-01*...

  • Page 2: Important Safety Instructions

    EXPLANATION OF TERMS AND SYMBOLS The term “WARNING!” indicates instructions regarding personal safety. If the instructions are not followed the result may be bodily injury or death. The term “CAUTION!” indicates instructions regarding possible damage to physical equipment. If these instructions are not followed, it may result in damage to the equipment that may not be covered under the warranty.

  • Page 3: Specifications And Dimensions

    40Hz to 400Hz AD-C10T-HPZB 60Hz to 20kHz Other product specifications and dimension drawings for the AD-C8T-ZB, AD-C8T-SWZB, and AD-C10T-HPZB can be found online at qsys.com. RoHS Statements The QSC Q-SYS AD-C8T-ZB, AD-C8T-SWZB, and AD-C10T-HPZB are in compliance with European RoHS Directive.

  • Page 4: Installation

    Installation — Figure 1 — Prepare Ceiling Refer to Figure 1. Use the template provided to mark and cut a hole (1) in the ceiling where the loudspeaker is to be installed. For a frame-construction ceiling, skip to “Wire the Loudspeakers”. 2.
  • Page 5 Mount the Loudspeaker Refer to Figure 1. Make sure all of the dog-ears are fully extended and in their non-capture position. 2. Position the loudspeaker into the hole prepared in the ceiling. 3. Use a Phillips screwdriver to tighten each of the three dog-ear screws. As you tighten the screws, the dog-ears will swing into capture position over the ceiling.

  • Page 6: Knowledge Base

    © 2025 QSC, LLC. All rights reserved. QSC and the QSC logo, Q-SYS, and the Q-SYS logo are registered trademarks of QSC, LLC in the U.S. Patent and Trademark Office and other countries. Patents may apply or be pending. All other trademarks are the property of their respective owners.

This manual is also suitable for:

Acousticdesign seriesAd-c8t-swzbAd-c10t-hpzb

Table of Contents