Q-SYS AcousticDesign Series Hardware User Manual
  1. Manuals
  2. Brands
  3. Q-SYS Manuals
  4. Speakers
  5. AcousticDesign Series
  6. Hardware user manual

Q-SYS AcousticDesign Series Hardware User Manual

Ceiling mount loudspeaker – low profile, zero bezel
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Hardware User Manual
AcousticDesign™ Series
AD-C6T-LPZB Ceiling Mount Loudspeaker – Low Profile, Zero Bezel
TD-001692-01-A
*TD-001692-01*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AcousticDesign Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Q-SYS AcousticDesign Series

Summary of Contents for Q-SYS AcousticDesign Series

  • Page 1 Hardware User Manual AcousticDesign™ Series AD-C6T-LPZB Ceiling Mount Loudspeaker – Low Profile, Zero Bezel TD-001692-01-A *TD-001692-01*...

  • Page 2: Important Safety Instructions

    EXPLANATION OF TERMS AND SYMBOLS The term “WARNING!” indicates instructions regarding personal safety. If the instructions are not followed the result may be bodily injury or death. The term “CAUTION!” indicates instructions regarding possible damage to physical equipment. If these instructions are not followed, it may result in damage to the equipment that may not be covered under the warranty.

  • Page 3: Specifications And Dimensions

    RoHS Statements The QSC Q-SYS AD-C6T-LPZB is in compliance with European RoHS Directive. The QSC Q-SYS AD-C6T-LPZB is in compliance with “China RoHS” directives. The following table is provided for product use in China and its territories. QSC Q-SYS AD-C6T-LPZB 部件名称...

  • Page 4: Installation

    Installation Prepare Ceiling Refer to Figure 1. 1. Use the template provided to mark and cut a hole (1) in the ceiling where the loudspeaker is to be installed. For a frame-construction ceiling, skip to “Wire the Loudspeakers”. 2. Install two V-rails (2), one on each side of the hole, and supported by the suspended-ceiling support rails (3).
  • Page 5 Mount the Loudspeaker Refer to Figure 5. 1. Make sure all of the dog-ears are fully extended and in their non-capture position. 2. Position the loudspeaker into the hole prepared in the ceiling. 3. Use a Phillips screwdriver to tighten each of the three dog-ear screws. As you tighten the screws, the dog-ears will swing into capture position over the ceiling.

  • Page 6: Knowledge Base

    © 2023 QSC, LLC. All rights reserved. QSC and the QSC logo, Q-SYS, and the Q-SYS logo are registered trademarks of QSC, LLC in the U.S. Patent and Trademark Office and other countries. Patents may apply or be pending. All other trademarks are the property of their respective owners.

This manual is also suitable for:

Ad-c6t-lpzb

Table of Contents