U-Line H-10988 Manual

H-10988
FORKLIFT CARPET POLE –
FORK MOUNT
These instructions use signal words to direct the user's
attention to important safety-related messages. These
messages describe uses of the product that could
result in personal injury or property damage. Each
signal word corresponds to a specific hazard level.
WARNING! Improper or careless use could
result in serious personal injuries or death.
• Failure to read and understand these instructions
before assembling, installing, using or servicing
the product in a misuse of the product. Read the
instructions to refresh your understanding of proper
use and maintenance procedures.
• Do not exceed the load capacity of unit.
• Inspect the carpet pole before each use as
described in "Inspections" on page 3.
• Always connect the safety chain to the carriage of
your forklift without slack. The unit must not be able
to slide on the forks.
• Verify that the load is stable by lifting the carpet
just a few inches above the ground. Load swing
should be minimal, and the carpet pole should
not shift on the forks. If the load is not stable while
elevated, return it to the ground and use another
device to transport it.
• Always apply the rules governing use of forklift
front end attachments applied at your work site.
PAGE 1 OF 11
1-800-295-5510
uline.com
SAFETY
• Do not cover or remove any label. Verify the
location and legibility of all labels. Do not use this
device unless all product labels are readable and
undamaged.
• Do not ride or sit on the carpet pole.
• Do not use the carpet pole to push objects. Only
use the product to transport a roll of carpet.
• Only use this product when traveling on firm, level,
even ground.
• Do not leave elevated rolls of carpet unattended.
Always lower the load before leaving the forklift.
• Carpet roll must not be longer than the pole. The
carpet roll must not hang over the end of the pole.
See Operation on page 2 for loading instructions.
• Do not modify the carpet pole in any way unless
you first obtain written approval from Uline. Contact
Uline Customer Service at 1-800-295-5510 for
assistance. Unapproved modifications might make
the product unsafe to use.
Para Español, vea páginas 4-7.
Pour le français, consulter les pages 8-11.
0224 IH-10988