Plasmapp STERLINK U510 Installation Manual

1 Location
Place the product in a flat, untilted
location with minimum 5 Cm distance
in each direction.
50mm
3 Check the LCD and warming up
operation
Make sure the front LCD shows the unit
is on and in stand-by mode. Load the
sterilization cartridge inside the chamber
and check if it's identified normally.
Run 2~3 cycle with no load for warming up
the unit by pressing the dial button after
selecting the mode if the unit is installed
for the first time or not used for a long time.
Installation Manual
50mm
50mm
x2
2 Connect the power plug into
the power socket
Put the power on using the power button
on the right side of the unit.
4
Proceed with the sterilization
Load the object for sterilization in the
Tyvek envelop or tray into the chamber,
select desired mode and start operation
using the dial button on the front of the unit.
www.plasmapp.com