Page 10
Ø Quick Parameters Settings: • Configuration According To Motor Type (Parameter FC.En Must Be Set To NO): • Enable or Disable the Photobeam Sensor (Parameter FOT2 Must be Set To NO if Sensor is not connected Or Before Running The Set Up Cycle): W: skylinegateautomation.com.au...
Page 11
• Setting The System For SINGLE/ DOUBLE GATE (Parameter t.AP2 Must Be Set to Zero(0) For Single Swing Gate – Don’t Do Any Changes If Its Double Swing Gate): • Set Up Cycle (Set The Gates Half-Open Using Manual Override Keys Before Running The Set Up Cycle): W: skylinegateautomation.com.au...
Page 12
• Final Setting & Saving: W: skylinegateautomation.com.au...
Page 13
Ø More Parameters Settings: • To Enable Automatic Closing: • Settings for Loop Detectors & Gate Timers: • Reset to Factory Default: W: skylinegateautomation.com.au...
Page 14
• To Adjust Motor Power During Normal Speed (Default Value is 80): • To Adjust Motor Power During Slowdown Speed (Default Value is 50): W: skylinegateautomation.com.au...
Need help?
Do you have a question about the SGA-MOOV500-24V and is the answer not in the manual?
Questions and answers