Replacing Components - BMW X3 2004 Owner's Manual

Replacing components

Onboard tool kit
The onboard tool kit is located in a com-
partment on the left under the cargo area.
Replacing wiper blades
Front
1. Move the wiper to a fold-out position,
refer to page 42
2. Lift the wiper arm and press the secur-
ing spring, refer to arrow
3. Pull the wiper blade off toward the
wiper arm
4. Insert the new blade and snap it into
place.
Fold the wipers back down onto the
windshield before you turn the igni-
tion key to position 1 or 2 again. If you do
not, they could be damaged.<
Rear
1.
2.
3.
Lamps and bulbs
The lamps and bulbs make essential contri-
butions to the safety of your vehicle. There-
fore, comply fully with the following instruc-
tions during bulb replacement. If you are
not familiar with the specified procedures,
BMW recommends having the replace-
ments carried out at your BMW Sports
Activity Vehicle Center.
amounts of contamination will burn into the
bulb's surface and reduce its service life.
To install, use a clean cloth, napkin etc. or
hold the bulb by its metal
A replacement bulb set is available from
your BMW Sports Activity Vehicle Center.
equipment or accessory you should always
switch it off and disconnect the cable from
the battery's negative terminal before start-
ing.
To avoid possible injury or equipment dam-
age when changing bulbs, observe any
instructions provided by the bulb manufac-
turer.<
Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG
Lift the wiper arm
Pull off the wiper blade, refer to arrow
Insert a new wiper blade.
Never touch the glass of new bulbs
with your bare fingers, as even minute
To prevent short circuits, before
working on any electrical system,
socket.<
99