Subscribe to Our Youtube Channel
Related Manuals for LANSEN LAN-WMBUS-GW5-BE-LR-A1 CATM1 Series
Summary of Contents for LANSEN LAN-WMBUS-GW5-BE-LR-A1 CATM1 Series
- Page 1 Q U I C K I N S T A L L A T I O N G U I D E OUTDOOR LONG-RANGE BATTERY GATEWAY WITH OPTIONAL USE FOR ONE OR TWO EXTERNAL ANTENNAS LAN-WMBUS-GW5-BE-LR-A1/A2-(X)-CATM1-(X) LAN-WMBUS-GW5-BE-LR-A1/A2-(X)-CAT1/4G-(X) Version 1.4...
- Page 2 Article Name Description LAN-WMBUS-D2-TC Lansen Configuration Warning, risk for bodily harm if handled Dongle without care. Lansen Configurator Software for Lansen Dongle LAN-CF-CABLE Configuration Cable, NOTICE: LAN-A-PMB-KIT- Pole mounting kit ID58-78 LAN-MAG-R4 Magnet with We are not responsible for any damage,...
-
Page 3: Label Information
868,600 B14/ B18/B19/B20/B2/ performance. B18/B19/B20/ B26/B28/B66/ B25/B26/B27/ N: 868,700 B28/B66/B85 For more information, go to our website: www.lansen.io. MHz to LTE-TDD 869,200 B34/B38/B39/ B40/ LABEL INFORMATION The label on the device gives useful information about your device, Output < 14 dBm /... - Page 4 Installing and mounting Step 2: Disconnect the battery, if connected, by pulling on the Step 1: battery cable (green circle). Unscrew the screw (red circle) and remove the cover by Prepare to insert a SIM-card (not included) by removing the pushing the clips (green circles) at both sides of the cover.
- Page 5 Continue to Step 7. Step 6: Mounting on a pole/mast (A2) Install the Lansen pole mounting kit (article number LAN- 910-0066) on the back of the gateway. Pull the straps through the holes and wrap it around the pole or pipe which the gateway is going to be mounted on and tighten the straps, so it is securely mounted.
- Page 6 A gateway has two places with LEDs One LED strip for status of complete, the device accepts configuration data. We the device (red circle) and one LED for status of cellular recommend configuring using a Lansen USB-dongle (LAN- connectivity (red arrow). WMBUS-D1/D2-TC) with the software Lansen Configurator during this time frame.
- Page 7 Note: Enable external antennas by configuring using a modem, Lansen USB-dongle (LAN-WMBUS-D2-TC) together with attempting the software Lansen Configurator or by sending the to connect command using MQTT. to a network. External antenna for cellular network Go to Step 12.
- Page 8 Note: Make sure to enable the parameter to use external Note: Make sure to enable the parameter to use external antenna for cellular network by using Lansen Configurator antenna for wM-Bus by using Lansen Configurator or or sending a command using MQTT.
- Page 9 Cellular SIMPLIFIED EU DECLARATION OF CONFORMITY Hereby, Lansen Systems AB declares that the radio equipment type defined by article name on the sticker is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.lansen.io/DOC...
Need help?
Do you have a question about the LAN-WMBUS-GW5-BE-LR-A1 CATM1 Series and is the answer not in the manual?
Questions and answers