Rear-Wheel Stand; Bulbs - BMW R 1200 R Rider's Manual

Rear-wheel stand

8
Installing rear-wheel
stand
110
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Use rear-wheel stand with tool
number (0 402 244) with ad-
apter shaft (0 402 250) appro-
priate to the motorcycle.
z
Use screws 1 to set the rear-
wheel stand to the desired
height.
Remove retaining disc 2. To
do so, press release button 3.
Push the rear-wheel stand from
the right onto the rear axle.
Push on retaining disc 2 from
the left, while holding the un-
lock button down.
Take a grip on the motorcycle
with your left hand, and place
your right hand on lever 4 of
the rear-wheel stand.
Lift the motorcycle upright,
simultaneously pressing the
lever down until the stand sup-
ports the motorcycle in the up-
right position.
Press the lever down to the
ground.

Bulbs

General instructions
A warning appears in the multi-
function display if a bulb is de-
fective. If the brake or rear light
fails, the symbol is accompan-
ied by the 'General' warning light,
which lights up yellow. If the rear