Table of Contents
Advertisement
Computer
After three incorrect code entries,
or three attempts to start the engine
without a code entry, the alarm will
sound for 30 seconds on vehicles
equipped with an alarm system.
Setting the alarm in an emergency:
If you have forgotten the code, proceed
as follows:
1. Disconnect the battery, wait about
2 minutes, then reconnect it. Note
that on vehicles with an alarm
system, the alarm will sound
2. Turn the ignition key to position 1:
The time display will count down for
the next ten minutes
3. After ten minutes, start the engine.
If the code becomes available
again in the meantime, it can be
entered during the waiting period after
pressing the CODE
button.<
Remote control
You can press the button in the turn
signal indicator lever to retrieve infor-
mation from the computer for display.
To do this, press:
> The button on the lever until PROG 1
shows on the display
> The MID buttons in the order in which
you wish the information to be dis-
played.
Each time an entry is stored, the pro-
gram number appears on the display.
To terminate the selection procedure:
Press the right side of the button.
To display all the available information,
press:
> The button on the lever until the dis-
play shows PROG 1
> The SET button.
To obtain individual items of informa-
tion, press the button in briefly as often
as necessary.
Online Edition for Part No. 01 41 0 156 830 - © 07/02 BMW AG
77n
Advertisement
Table of Contents
