Table of Contents
Advertisement
Lamps and bulbs
Xenon lamps
The service life of these bulbs is very
long and the probability of a failure is
very low, provided that they are not
switched on and off an unusual number
of times. If one of these bulbs should
nevertheless fail, it is possible to con-
tinue driving with great caution using
the fog lamps, provided traffic laws in
your area do not prohibit this.
Never attempt to perform bulb
changes or any other service oper-
ations on the xenon lamps. Always have
them serviced by professional techni-
cians. The extremely high voltages at
which these lamps operate constitute a
potentially lethal safety
hazard.<
When cleaning the headlamps,
please observe the following:
> Do not clean by wiping with a dry
cloth (this causes scratches). Never
use abrasives or strong solvents to
clean the covers
> Remove dirt and contamination (such
as insects) by soaking with BMW Car
Shampoo and then rinsing with
ample water
> Always use a deicer spray to remove
accumulated ice and snow – never
use a
scraper.<
Standing lamps
10 watt bulb
The bulb holder and reflector are a
single unit and are both changed
at the same
time.<
1. Turn the bulb holder with reflector
to the left (arrow) and remove
2. Disconnect the plug
3. Plug the new bulb holder into the
plug connector. Be sure that it is
securely engaged
4. Insert the reflector with bulb holder
and turn to the right as far as
possible.
Turn signal indicators/parking
lamps (side marker lamps), front
Dual-filament bulb, 21 watt
1. Turn the bulb holder to the left and
remove
2. Remove and replace the bulb.
Online Edition for Part No. 01 41 0 156 830 - © 07/02 BMW AG
125n
Advertisement
Table of Contents
