Table of Contents
Advertisement
Jump-starting
7. Start the support vehicle's engine
and let it run. Start the engine on the
vehicle needing the jump-start, and
allow it to run as usual. If the first
start attempt is not successful, wait a
few minutes before another attempt
in order to allow the discharged
battery to recharge
8. Before disconnecting the jumper
cables let the engines run for a few
minutes
9. Then disconnect the jumper cables
in reverse sequence.
Depending on the cause of the fault,
recharge the battery.
Towing the vehicle
Tow fitting
The screw-in tow fitting is stored in the
onboard tool kit; be sure that it remains
in the vehicle at all times. This fitting
is designed for installation in the tow
sockets located at the front and rear of
the vehicle, and is intended for towing
on paved road surfaces only.
It should not be used to pull a vehicle
out of deep snow, mud, sand, etc.
Comply with all applicable towing laws
and regulations at all times.
Access to tow sockets
Front:
Use a screwdriver to press the cover
out.
Rear:
Use a screwdriver to press the cover
out.
Screw the tow fitting in until it is
tight against the stop. If you do
not, the threads can be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do so, the
components could be damaged,
leading to possible
accidents.<
Use only a nylon towing strap to tow
the vehicle, since the inherent resil-
ience of this material helps protect both
vehicles from sudden jerking move-
ments.
Online Edition for Part No. 01 41 0 156 429 - © 10/01 BMW AG
139n
Advertisement
Table of Contents
