Device Overview; Use Instructions - AbleNet One Instructions For Use

DEVICE OVERVIEW

USE INSTRUCTIONS

Compatibility
The mounting arm is compatible with AbleNet Quick Ready Mounting Plate for Assistive Technology or
mounting plates that use a ¼"-20 threaded rod to attach.
First Time Use
1. Attach the One mounting arm to table, wheelchair, or other surface using the Clamp. Turning
the handle on the Clamp counterclockwise will loosen or open the Clamp to fit on larger
surfaces. Turning the handle on the clamp clockwise will tighten the clamp.
a. If attaching to a tubular surface (e.g. wheelchair arm), remove the wedge inside the
clamp by firmly grasping both sides of the wedge and and pulling up.
2. Attach the threaded bolt side of the mounting plate (not included) to the end of the mounting
arm.
3. Use Friction Knob Handle to adjust the mounting arm. Turning the Friction Knob Handle
counterclockwise to loosen and then clockwise to tighten after positioning the mounting arm.
Instructions for Use – One
Page 3 of 5